Filter
Top Products
Surround sound settings
08
38
En
Dynamic Range Control
1
When watching Dolby Digital or DTS material at low
volume, low level sounds — including some of the dialog
— can be difficult to hear properly. Using one of the
Dynamic Range Control (DRC) settings can help by
bringing up the low level sounds, while controlling high
level peaks.
Dynamic Range Control works only with Dolby Digital
soundtracks and some DTS soundtracks.
1
Open the ‘Sound Setup’ menu.
2 Select ‘D.R.C.’, then press ENTER.
3 Select a setting.
Select one of the following:
•
D.R.C. Auto
– Only available for Dolby TrueHD
signals. Select
D.R.C. High
or
D.R.C. Mid
for signals
other than Dolby TrueHD.
•
D.R.C. High
– Dynamic range is reduced (loud
sounds are reduced in volume while quieter sounds
are increased)
•
D.R.C. Mid
– Mid setting
•
D.R.C. Off
– No dynamic range adjustment (use
when listening at higher volume)
4 Press to exit.
Dual mono setting
2
Specifies how dual mono encoded Dolby Digital
soundtracks should be played. You can also use this
setting to switch the audio channel on DVD-RW discs
recorded with bilingual audio.
1
Open the ‘Sound Setup’ menu.
2 Select ‘Dual Mono’, then press ENTER.
3 Select a setting.
Select one of the following:
•
CH1 Mono
– Only channel 1 is played
•
CH2 Mono
– Only channel 2 is played
•
CH1/CH2
– Both channels are played through the
front speakers
4 Press to exit.
Note
1 This setting is effective for the speaker output. A similar adjustment feature is available on the HDD/DVD recorder — see
Audio DRC
on
page 156.
SETUP
ENTER
ENTER
ENTER
2 This setting is effective for the speaker output. A similar adjustment feature is available on the HDD/DVD recorder — see
Switching audio chan-
nels
on page 111.
SETUP
ENTER
ENTER
ENTER
01SX-SW70SW_EN.book 38 ページ ２００７年７月１７日 火曜日 午後８時２８分