Filter
Top Products
Before you start
04
28
En
Basic operation
This manual is split into two parts, one covering using the
receiver subwoofer, the other using the HDD/DVD
recorder. Below are some common operations and
where to find them explained in this manual.
Operating the remote control
The supplied remote control can control not only the
receiver subwoofer and HDD/DVD recorder, but also
other Pioneer products such as Blu-ray disc players, DVD
players, and plasma televisions.
To operate these components, orient the remote control
toward the display unit.
Operating the receiver subwoofer
• Press to display the RECEIVER screen.
The
RECEIVER
screen is shown on the remote control’s
LCD screen, and the remote is switched to Receiver
mode.
Choosing and operating a source component
1
Press to cycle through connected components.
The selected component changes, and the LCD screen
on the remote control changes to that of the appropriate
component.
• To select input for
Digital 1
,
Digital 2
,
Analog
,
Front
Audio In
, or
iPod
, press the
LINE
button until the
desired input function is shown on the display unit.
2 Choose the input source you are using when you
have selected HDMI 1 to HDMI 3 or LINE.
The LCD screen changes to that for the selected
component, and you can then operate the desired
component.
• When the desired source cannot be found, or when
you have a component not manufactured by Pioneer
connected, press
RCV
to put the remote control into
Receiver mode. The input for this unit remains
unchanged.
Note
To temporarily control the receiver while listening to
audio from a connected component on this unit,
press
RCV
. The selected input will not change, and
the remote changes to Receiver mode. To return to
the previous operating mode, press
RCV
once more.
Using the LCD touch screen
Depending on the type of connected component you are
operating (such as an HDD/DVD recorder), there may be
multiple pages of information for the LCD touch screen.
When the component you would like to control is not
displayed, press
PAGE
to scroll to the page where the
component you would like to control is located.
• When no operations are carried out for over 10
seconds, the display on the LCD touch screen of the
remote control is automatically turned off. To have
the display shown once again, either touch the LCD
or press a button on the remote control.
Watching a DVD
Remember that when using the remote to control the
supplied HDD/DVD recorder, you should point the
remote towards the display unit, not the recorder itself.
1 Switch on the receiver subwoofer.
2 Set the remote control to HDD/DVR mode.
The LCD screen changes to that for the HDD/DVD
recorder, and you can then operate the desired
component (see
Choosing and operating a source
component
above).
3 Switch on the HDD/DVD recorder.
4 Switch on your TV.
Turn on your TV and make sure that it is set to the HDMI
video input.
5 Press to select DVD.
6 Press on the HDD/DVD recorder to open
the disc tray.
RCV
RECEIVER
SURR
ADV
SURR
F.S.
SURR
HDMI
123
TV
LINE
FM/AM
EXIT
BD DVD
HDD/
DVR
EXIT
BD DVD
HDD/
DVR
TV
HDMI input LINE input
RECEIVE
R
SOURC
E
TV
HDD/
DVD
OPEN/
CLOSE
01SX-SW70SW_EN.book 28 ページ ２００７年７月１７日 火曜日 午後８時２８分