Filter
Top Products
Connecting up
02
11
En
1 Connect the display unit to the receiver subwoofer.
Plug the display cable into the connector on the rear of
the display unit, then plug the other end of the display
cable into
SYSTEM
connector on the receiver subwoofer.
Caution
• Do not attempt to attach the display unit to the wall.
2 Assemble the AM loop antenna.
a. Bend the stand in the direction indicated by the
arrow.
b.Clip the loop onto the stand.
c. If you want to fix to a wall or other surface, perform
step b after first securing the stand with screws.
It is recommended that you determine the reception
strength before securing the stand with the screws.
3 Connect the AM and FM antennas
1
.
a. Connect one wire of the AM loop antenna to each AM
antenna terminal
2
.
For each terminal, press down on the tab to open;
insert the wire, then release to secure.
b. Push the FM antenna
3
plug onto the center pin of the
FM antenna socket.
4 Connect each speaker.
• Each speaker cable has a colour-coded connector at
one end and two wires at the other end.
• Twist and pull off the protective shields on each wire.
• Connect the wires to the speaker. Each speaker in the
illustration can be identified by means of the colour-
coded indicator provided on the rear-surface model
label. Match the colour-coded wire with the colour
indicator on the model label, then insert the colour-
coded wire into the red (
+
) side and the other wire
into the black (
–
) side.
• Connect the other end to the colour-coded speaker
terminals on the side of the receiver subwoofer. Make
sure to insert completely.
Be careful when inserting the speaker plug, as it
must be inserted in the proper direction when being
plugged into one of the terminals. Please make sure
to connect correctly.
Note
1• Keep antenna cables away from other cables, the display unit, receiver subwoofer and HDD/DVD recorder.
• If reception with the supplied antenna is poor, see
Improving poor FM reception
and
Improving poor AM sound
on page 35 or
Connecting
external antennas
on page 42.
• Do not attach any antenna other than the provided loop antenna, or an external antenna as described on page 43.
2• Don’t let it come into contact with metal objects and avoid placing near computers, television sets or other electrical appliances.
• If radio reception is poor, you may be able improve it by re-inserting each antenna wire into the opposite terminal.
• For best reception, do not untwist the AM loop antenna wires or wrap them around the loop antenna.
3 To ensure optimum reception, make sure the FM antenna is fully extended and not coiled or hanging at the rear of the unit.
a b c
1
2
3
Colour-coded wire
(Connect to speaker)
Colour-coded connector
(Connect to receiver subwoofer)
Black (–) Red (+)
Colour-coded wire
01SX-SW70SW_EN.book 11 ページ ２００７年７月１７日 火曜日 午後８時２８分