Filter
Top Products
Listening to the radio
07
35
En
Chapter 7
Listening to the radio
Important
• To listen to the radio, press the
FM/AM
button
to set the remote control to FM/AM control mode. The
LCD screen on the remote control changes to the
FM/AM
screen.
Listening to the radio
The tuner can receive both FM and AM broadcasts, and
lets you memorize your favorite stations so you don’t have
to manually tune in every time you want to listen.
1
Switch to the tuner, then press repeatedly to
select the FM or AM band.
The display shows the band and frequency.
2
Tune to a frequency.
There are three tuning modes — manual, auto, and high-
speed:
•
Manual tuning
– Press
TUNE +/–
repeatedly to
change the displayed frequency.
•
Auto tuning
– Press and hold
TUNE +/–
until the
frequency display starts to move, then release. The
tuner will stop on the next station it finds. Repeat to
keep searching.
•
High-speed tuning
– Press and hold
TUNE +/–
until
the frequency display starts to move rapidly. Keep the
button held down until you reach the frequency you
want. If necessary, fine tune the frequency using the
manual tuning method.
Improving poor FM reception
If you’re listening to an FM station in stereo but the
reception is weak, you can improve the sound quality by
switching to mono.
1 Press after tuning to an FM radio station.
2 Select ‘Tuner Setup’ then press ENTER.
3 Choose ‘FM Auto/Mono’ then press
ENTER.
4 Select ’FM Mono’ then press ENTER.
The mono indicator ( ) lights when the tuner is in mono
reception mode.
Select
FM Auto
above to switch back to auto-stereo
mode (the stereo indicator ( ) lights when receiving a
stereo broadcast).
Improving poor AM sound
The simplest way to improve the sound quality of AM
radio is to make sure that the TV in the room is switched
off. Also try changing the position and direction of the
AM loop antenna.
Changing the noise cut mode
If you find that the AM sound quality is bad even after
trying the above, you may be able to improve it using a
different noise cut mode. Just choose the one that
sounds best.
1 Press after tuning to an AM radio station.
2 Select ‘Tuner Setup’ then press ENTER.
3
C
hoose ‘Noise Cut’ then press ENTER.
4
S
elect a Noise cut mode (1, 2 or 3) then
press ENTER.
Memorizing stations
You can save up to 30 station presets so that you always
have easy access to your favorite stations without having
to tune in manually each time.
1 Tune to an FM or AM radio station.
Select mono or auto-stereo reception (FM) or the Noise
Cut mode (AM) as necessary. These settings are saved
along with the preset.
2
Press
SETUP
.
3
Select ‘Tuner Setup’ then press ENTER.
FM/AM
FM/AM
123
FM/AM
-
+
TUNE
SETUP
ENTER
ENTER
ENTER
SETUP
ENTER
ENTER
ENTER
SETUP
ENTER
01SX-SW70SW_EN.book 35 ページ ２００７年７月１７日 火曜日 午後８時２８分