Filter
Top Products
Troubleshooting
58
The display is dark
r
Make sure that Dimmer function is not working. Press
DIMMER button and change the brightness level of the
display.
The following settings can be made for the
composite video inputs
r
While holding down the input selector button to
configure, press HOME once at a time until “Video
ATT:On” appears on the display. To resume the setup,
repeat the above described step until “Video ATT: Off” is
appeared on the display.
This setting is possible for input selectors assigned with
one of the video inputs "VIDEO 1" to "VIDEO 3" in "1.
Input/Output Assign" - "Composite Video Input". If you
have a game console connected to the composite video
input, and the picture is not very clear, you can attenuate
the gain.
Video ATT:Off: (default).
Video ATT:On: (Gain is reduced by 2dB.)
If the picture on your TV/monitor connected to the
HDMI output(s) is unstable
r
Try turning the DeepColor function off. To turn off
the DeepColor function, press STB/DVR and
ON/
STANDBY on the AV receiver simultaneously.
While holding down STB/DVR, press
ON/STANDBY
repeatedly until “Deep Color:Off” is appeared on the
display. To reactivate the DeepColor function, repeat the
above described step until “Deep Color:On” is appeared
on the display.
The AV receiver contains a microPC for signal processing
and control functions. In very rare situations, severe
interference, noise from an external source, or static
electricity may cause it to lockup. In the unlikely event that
this happens, unplug the power cord from the wall outlet,
wait at least 5 seconds, and then plug it back in.
Onkyo is not responsible for damages (such as CD rental
fees) due to unsuccessful recordings caused by the unit’s
malfunction.
Before you record important data, make sure that the
material will be recorded correctly.
Before disconnecting the power cord from the wall outlet,
set the AV receiver to standby.