Onkyo HT-R993 Stereo Receiver User Manual


 
3
AM/FM Radio Receiving Function
Presetting an AM/FM Radio Station
It allows you to register up to 40 of your favorite AM/FM
radio stations. Registering radio stations in advance allows
you to tune into your radio station of choice directly.
Registration Procedure
1.
Tune into the AM/FM radio station you want to register.
2.
Press MEMORY on the unit so that the preset number
on the display flashes.
3.
Repeatedly press PRESET to select a number
between 1 and 40 while the preset number is flashing
(about 8 seconds).
4.
Press MEMORY again to register the station.
r When the station is registered, the preset number
stops flashing.
r Repeat this procedure for all of your favorite AM/FM
radio stations.
Selecting a Preset Radio Station
1.
Press CH +/- on the remote controller to select a preset
number.
r Alternatively you can press
PRESET on the
main unit. You can also select by directly entering
the preset number with the number buttons on the
remote controller.
Deleting a Preset Radio Station
1.
Press CH +/- on the remote controller to select the
preset number to delete.
2.
Press and hold MEMORY on the main unit and press
TUNING MODE to delete the preset number.
r When deleted, the number on the display goes off.
Using RDS (European model)
RDS stands for Radio Data System and is a method of
transmitting data in FM radio signals.
r
RDS works only in areas where RDS broadcasts are
available.
r
In some cases, the text information appeared on the
display is not identical to the content transmitted by
the RDS station. Furthermore, unexpected characters
may be displayed when the unit receives unsupported
characters. However, this is not a malfunction.
r
If the signal from an RDS station is weak, the RDS data
may be displayed continuously or not at all.
PS (Program Service): Tuning into a radio station
distributing Program Service information displays the
radio station name. Pressing DISPLAY displays the
frequency for 3 seconds.
RT (Radio Text): Tuning into a radio station transmitting
Radio Text information displays text on the display of the
unit.
PTY (Program Type): Allows you to search for RDS
stations by program type.
TP (Traffic Program): Allows you to search for radio
stations transmitting traffic information.
Displaying Radio Text (RT)
1.
Press RT/PTY/TP on the main unit once.
r The Radio Text (RT) is displayed scrolling across
the display. "No Text Data" is displayed when no text
information is available.