Filter
Top Products
Advanced Settings
28
r
When the speaker is set to "No" in "Speaker Configuration", the settings for "Speaker Distance"
cannot be changed.
r
Default values vary depending on the regions.
Level Calibration
Adjust the level of each speaker with the built-in test tone. Settings are automatically
configured if you use the Automatic Speaker Setup.
Setting Item Default Value Setting Details
Front Left 0dB Select a value between "-12dB" to "+12dB". A
test tone will be output each time you change
the value. Select the desired level.
Center 0dB Select a value between "-12dB" to "+12dB". A
test tone will be output each time you change
the value. Select the desired level.
Front Right 0dB Select a value between "-12dB" to "+12dB". A
test tone will be output each time you change
the value. Select the desired level.
Surround Right 0dB Select a value between "-12dB" to "+12dB". A
test tone will be output each time you change
the value. Select the desired level.
Back Right 0dB Select a value between "-12dB" to "+12dB". A
test tone will be output each time you change
the value. Select the desired level.
r
The setting is not displayed if "Speaker
Configuration" - "Back" is set to "Yes" and
also "Back ch" is set to "1ch".
r
The setting cannot be changed if any type
is selected in "Speaker Settings" - "Height
Speakers Type".
r
The setting cannot be changed if "Speaker
Settings" - "Powered Zone 2" is set to "Yes"
and also Zone2 is set to on.
Setting Item Default Value Setting Details
Back Left 0dB Select a value between "-12dB" to "+12dB". A
test tone will be output each time you change
the value. Select the desired level.
r
The setting is not displayed if "Speaker
Configuration" - "Back" is set to "Yes" and
also "Back ch" is set to "1ch".
r
The setting cannot be changed if any type
is selected in "Speaker Settings" - "Height
Speakers Type".
r
The setting cannot be changed if "Speaker
Settings" - "Powered Zone 2" is set to "Yes"
and also Zone2 is set to on.
Back 0dB Select a value between "-12dB" to "+12dB". A
test tone will be output each time you change
the value. Select the desired level.
r
The setting is displayed only if "Speaker
Configuration" - "Back" is set to "Yes" and
also "Back ch" is set to "1ch".
r
The setting cannot be changed if any type
is selected in "Speaker Settings" - "Height
Speakers Type".
r
The setting cannot be changed if "Speaker
Settings" - "Powered Zone 2" is set to "Yes"
and also Zone2 is set to on.
Surround Left 0dB Select a value between "-12dB" to "+12dB". A
test tone will be output each time you change
the value. Select the desired level.
Subwoofer 0dB Select a value between "-15dB" to "+12dB". A
test tone will be output each time you change
the value. Select the desired level.
Height Left 0dB Select a value between "-12dB" to "+12dB". A
test tone will be output each time you change
the value. Select the desired level.
r
This setting cannot be changed in any of the
following cases.
– "Speaker Settings" - "Height Speakers
Type" is set to "Not Use".
– "Speaker Settings" - "Powered Zone 2" is
set to "Yes" and also Zone2 is set to on.