Filter
Top Products
Connecting and Operating Onkyo RI Components
48
Connecting and Operating
Onkyo RI Components
About RI Function
Connecting an Onkyo component with RI jack such as
the separately sold RI Dock to the unit by using an RI
cable and an analog audio cable enables the following RI
functions:
System On / Auto Power On: Starting playback on a
component connected via RI when the unit is on standby
mode, automatically turns on the unit to select the relevant
component as its input source.
Direct Change: When playback is started on a component
connected via RI, the unit selects that component as the
input source.
Remote Controller Operation: Allows you to operate RI-
compatible Onkyo components using the AV receiver's
remote controller. Point the remote controller at remote
control sensor of the unit. This operation is possible only
when the RI remote control code is programmed.
r
Some components may not support all RI functions.
r
These functions do not work when Zone 2 is turned on.
r
For information on the RI functions, also refer to each
component's instruction manual.
RI Connection and Setting
R
L
Connect an Onkyo component with RI jack to this unit using
an RI cable and an analog audio cable. For details, refer
to the instruction manual of the component with RI jack.
The RI cable can be connected in any order. When there
are two RI jacks, both jacks work in the same way and are
interchangeable.
To connect the RI Dock or cassette tape deck via RI, you
must:
To rename the input selector
To make the RI functions work, you must rename the input
selectors on the unit. Press TV/CD or GAME to display
"TV/CD" or "GAME" on the main unit display. Then press
and hold TV/CD or GAME 3 seconds or more to switch the
display to "DOCK" or "TAPE".
To program the RI remote control code
Program the remote control code to any REMOTE MODE
button on the remote controller. This will allow you to
operate the component by pointing the remote controller at
the unit instead of the component.
1.
Press DISPLAY for 3 or more seconds while holding
down the REMOTE MODE button to which you want to
program the remote control code.
r The remote indicator will light.
r The RCV, ZONE2, and TV buttons cannot be
programmed.
2.
With the number buttons, enter the following 5-digit
remote control code within 30 seconds.
RI Dock: 81993
Cassette tape deck with RI jack: 42157
r Programming is complete when the remote indicator
flashes twice. The remote indicator flashes once
slowly when programming the remote control code
fails. Try programming again.
Change the input selector on the RI Dock to "DOCK"
or "TAPE". For details, refer to the RI Dock's instruction
manual.
To operate Onkyo components directly or Onkyo
components that are not connected via RI, use the
following remote control codes:
Onkyo DVD player: 30627
Onkyo CD player: 71817
RI Dock: 82990
r
With some models, operation may be not possible in
part or not possible at all.