Filter
Top Products
AM/FM Radio Receiving Function
2
AM/FM Radio Receiving Function
Tuning into a Radio Station
Tuning into stations automatically
1.
Press TUNER on the main unit several times to select
either "AM" or "FM".
2.
Press TUNING MODE so that the "AUTO" indicator on
the display lights.
3.
Press TUNING to start automatic tuning.
r Searching automatically stops when a station is
found. When tuned into a radio station, the "
TUNED " indicator on the display lights. If FM
stereo broadcasting is tuned, the "FM STEREO"
indicator lights.
r No sound is output while the "
TUNED " indicator
is off.
When the signal from an FM radio station is weak:
Radio wave may be weak depending on the building
structure and environmental conditions. In that case,
manually tune into the radio station of your choice by
referring to the next section.
Tuning into stations manually
1.
Press TUNER on the main unit several times to select
either "AM" or "FM".
2.
Press TUNING MODE so that the "AUTO" indicator on
the display goes off.
3.
Press TUNING to select the desired radio station.
r The frequency changes by 1 step each time
you press the button. The frequency changes
continuously if the button is held down and stops
when the button is released. Tune by looking at the
display.
To return the display to "AUTO": Press TUNING MODE
on the main unit again. A station is automatically tuned.
Normally "AUTO" should be displayed.
Tuning into stations by frequency
It allows you to directly enter the frequency of the radio
station you want to listen to.
1.
Press TUNER on the remote controller several times to
select either "AM" or "FM".
2.
Press D.TUN.
3.
Using the number buttons, enter the frequency of the
radio station within 8 seconds.
r To enter 87.5 (FM), for example, press 8, 7, 5, or 8,
7, 5, 0. If you entered a wrong number, press D.TUN
and enter a correct one.