Filter
Top Products
NILES AUDIO CORPORATION – 1-800-BUY-HIFI – 305-238-437338
ZONE 4 PRE-OUT
The ZR-6 MultiZone Receiver is equipped with Zone 4 pre-amplifi er
outputs that enable the use of a separate outboard power amplifi er.
This must be confi gured on each slave as well as the master.
While in the confi guration mode (see above), press the Set
button until the display shows [ZONE 4 PRE-OUT VARIABLE].
The default setting is for the preamplifi er outputs to be variable (the
output level is controlled by the ZR-6 volume control).
ZONE 4 PREOUT
VARIABLE
To change these outputs to a fi xed volume level, press the Band
button. The display will show [PRE-OUT 4 FIXED]. The Zone 4
Output is now set to +6dB relative to the selected source device
input level.
ZONE 4 PREOUT
FIXED
To continue to the next system confi guration step, Zone 5 Pre-Out,
press the Set button once.
To save the settings and exit the confi guration mode,
simultaneously hold down the Band and Set buttons. After the
ZR-6 saves the information. [RELEASE BUTTONS TO CONTINUE]
appears on the display. The ZR-6 will return to the normal operating
mode.
ZONE 5 PRE-OUT
The ZR-6 MultiZone Receiver is equipped with Zone 5 pre-amplifi er
outputs that enable the use of a separate outboard power amplifi er.
This must be confi gured on each slave as well as the master.
While in the confi guration mode (see above), press the Set
button until the display shows [ZONE 5 PRE-OUT VARIABLE].
The default setting is for the preamplifi er outputs to be variable
(controlled by the ZR-6 volume control).
ZONE 5 PREOUT
VARIABLE
To change these outputs to a fi xed volume level, press the Band
key. The display will show [PRE-OUT 5 FIXED]. The Zone 5 Output
is now set to +6dB relative to the selected source input level .
ZONE 5 PREOUT
FIXED
To continue to the next system confi guration step,
Zone 6 Pre-Out
,
press the Set button once.
To save the settings and exit the confi guration mode,
simultaneously hold down the Band and Set buttons. After the
ZR-6 saves the information, [RELEASE BUTTONS TO CONTINUE]
appears on the display. The ZR-6 will return to the normal operating
mode.
ZONE 6 PRE-OUT
The ZR-6 MultiZone Receiver is equipped with Zone 6 pre-amplifi er
outputs that enable the use of a separate outboard power amplifi er.
This must be confi gured on each slave as well as the master.
While in the confi guration mode (see above), press the Set button
until the display shows [ZONE 6 PRE-OUT VARIABLE]. The default
setting is for the preamplifi er outputs to be variable (controlled by
the ZR-6 volume control).
ZONE 6 PREOUT
VARIABLE
SYSTEM CONFIGURATION
(CONTINUED ON NEXT PAGE)
CONFIGURING THE ZR-6 MULTIZONE RECEIVER