Filter
Top Products
37NILES AUDIO CORPORATION – 1-800-BUY-HIFI – 305-238-4373
SYSTEM CONFIGURATION
Press the + button or - button to toggle the cursor between the
zones . A “Y” appears under every zone number. The cursor
under the zone number blinks when a zone is highlighted.
Press the Band button to toggle the “Y” on or off in the
highlighted zone. Only zones with a “Y” will respond to whole
house turn on.
123456
YYY
PARTY
MASTER
NOTE: IN THIS EXAMPLE ZONES 1, 2 AND 3 ARE CONFIGURED FOR
PARTY MODE.
After “6” on the Master, it will toggle to “1” on the fi rst
connected Slave. After “6” on the last connected Slave, it will
toggle back to “1” on the Master.
Repeat these steps until all of the desired zones have been set for
the desired Party mode operation.
To continue to the next system confi guration step,
PAGE MODE
VOLUME
, press the Set button once.
To save the settings and exit the confi guration mode,
simultaneously hold down the Band and Set buttons. After the
ZR-6 saves the information, [RELEASE BUTTONS TO CONTINUE]
appears on the display. The ZR-6 will return to the normal operating
mode.
PAGE MODE VOLUME
The paging volume level for the selected zones is adjustable.
Paging level must be set on each slave as well as the master.
Since the paging volume level will be the same for all zones
connected to that chassis, we suggest setting a comfortable
level in the room that will be used most frequently, or in the
smallest room. While in the confi guration mode (see above), press
the Set button until [PAGE MODE VOLUME = XX] shows in
the display.
PAGE MODE
VOLUME = 60
Press the + button to increase the paging volume. Press the - key
to decrease the paging volume. The factory default setting is 60.
The volume range is from 0 to 99.
PAGE MODE
VOLUME = 34
To continue to the next system confi guration step,
Zone 4 Pre-Out
,
press the Set button once.
To save the settings and exit the confi guration mode,
simultaneously hold down the Band and Set buttons. After the
ZR-6 saves the information, [RELEASE BUTTONS TO CONTINUE]
appears on the display. The ZR-6 will return to the normal operating
mode.
MAXIMUM VOLUME LEVEL
A Maximum Volume Level can be confi gured for each zone. The
volume level in zone will never exceed this Maximum level. The
default maximum volume level in a zone is 100%. When the
volume in a zone is at the maximum level, the volume bar indicator
on the keypad or touch panel shall indicate 100%.
While in the confi guration Menu, press SET until [SET MAX
VOLUME] is displayed.
SET MAX VOLUME
-/NO +/YES
Press + to confi gure Maximum Volume levels for each zone. [ZONE
1 MAX VOLUME] will appear on the display. Press the – button
to move to the next confi guration step without setting maximum
volume levels.
ZONE 1 MAX VOLUME
VOLUME= 90MASTER
Press + to raise the volume and press – to lower the volume. Press
SET to save the maximum volume setting and move to the next
step. After Zone 6 on the Master, Zone 1 on Slave 1 (if connected)
will be displayed. After Zone 6 on Slave 2 (if connected), the
confi guration menu will move to Zone 4 Pre out on the Master
ZONE 2 MAX VOLUME
VOLUME=100MASTER
CONFIGURING THE ZR-6 MULTIZONE RECEIVER