Filter
Top Products
Basic Operation
JBL Synthesis
2-8
REMOTE CONTROL OVERVIEW
The SDP-5 remote control provides full operation of the SDP-5,
performing commands such as menu navigation that are not
available from the front panel. The command matrix that begins
on page 2-13 indicates the commands remote control buttons
perform when each command bank is active. The numbered items
in the matrix correspond with the remote control illustrations on
pages 2-13 to 2-16.
OPERATION CONSIDERATIONS
The bulleted items that begin below describe factors that can
improve or impede remote control operation. It is recommended
to observe these items as well as the battery installation instructions
on page 1-5 before operating the remote control.
Please note the following before operating the SDP-5 remote
control:
• The remote control must be in line-of-sight with the front
panel IR receiver (2-3). Eliminate obstructions between the
remote control and the IR receiver. The remote control might
become unreliable if strong sunlight or fluorescent light is
shining on the IR receiver.
• For optimal performance, position the remote control at a
30 degree angle no more than 17 feet (5m) from the SDP-5. If
the SDP-5 is placed inside a glass cabinet, smoked glass will
reduce the remote control range.
• Remote controllers for different components can interfere with
one another. It is recommended to avoid using remote controls
for different components at the same time.
• The remote control batteries should be replaced as needed.
Refer to page 1-5 for battery installation instructions.
MAIN MENU
The MAIN MENU shown at the right
represents the beginning of the menu
structure. It can be used to open the three
main menu branches: MODE ADJUST,
AUDIO CONTROLS, and SETUP. Refer to
Sections 5, 4, and 3 for information about
these menu branches.
Refer to the Menu Navigation table on the next page for
instructions to open and close the MAIN MENU.
MENU NAVIGATION
The remote control Menu arrows must be used to navigate the
extensive menu structure shown in the Appendix (A-4 to A-13).
The table on the next page indicates the navigation functions
remote control Menu arrows perform when the Main Zone
command bank is activated.
MENU ITEM SELECTION
The remote control Menu arrows must be used to select menu items.
To select a menu item on the open menu:
1. Press the remote control Menu and arrows to highlight
the desired menu item.
2. When the desired menu item is highlighted, press the Menu
arrow to select the highlighted item. If an option is selected,
another menu will open. If a parameter is selected, a parameter
drop-down menu will open.
MAIN MENU
MODE ADJUST
AUDIO CONTROLS
SETUP