Filter
Top Products
Appendix
SDP-5
A-13
SPEECH DETECT
ON
OFF
-5 to +5dB
SURROUND MIX
OFF, -30 to +12dB
SUB LEVEL
500Hz to 20.0kHz, OFF
SURR ROLLOFF
0 to 15ms
SURROUND DLY
AUTO
ON
OFF
SURROUND EX
+6.0dB
+3.0dB
+0.0dB
VOCAL ENHANCE
FRONT
NEUTRAL
REAR
SOUND STAGE
When the Shift command bank is active, pressing the remote control Stat button opens the STATUS menu for the current
input source. This menu contains parameters that provide information about the current input source and listening mode.
STATUS menus are available for 2-channel, Dolby Digital, dts(-ES), digital, and analog input sources. Refer to page 2-18
for more information.
STATUS menu parameters provide information about the current input source and listening mode. These parameters
cannot be adjusted. Refer to the STATUS Menu Parameter Descriptions section that begins on page 2-23 for more
information.
2CH STATUS
INPUT
MODE
INPUT TYPE
SAMPLE RATE
L C R SL SR SB LFE
X X X XXX X
5.1a BYPASS STATUS
INPUT
MODE
INPUT TYPE
2CH BYPASS STATUS
INPUT
MODE
INPUT TYPE
DIGITAL STATUS
INPUT
MODE
INPUT TYPE
SAMPLE RATE
0
-6
-15
-30
-45
dB
%!D STATUS PG1
INPUT
MODE
CHANNELS
BIT RATE
EX ENCODIN G
LCRSLSRSB LFE
XXXXXX X
0
-6
-15
-30
-45
dB
DTS-ES STATUS PG1
INPUT
MODE
CHANNELS
BIT RATE
ESI ENCODING
LCRSLSRSBLFE
XXXXXXX
0
-6
-15
-30
-45
dB
%!D STATUS PG2
SAMPLE RATE
2.0 ENCODING
DIALOG OFFSET
MIX ROOM
CENTER MIX LVL
SURR MIX LVL
DTS-ES STATUS PG2
WORD LENGTH
SAMPLE RATE
Activating the SDP-5 while pressing and holding the
front panel or remote control Mute button opens the
FACTORY SETTINGS menu shown below. Refer to page
6-4 for more information.
FACTORY SETTINGS
EXIT
RESTORE DEFAULTS
FACTORY SETTINGS
HAVE BEEN RESTORED
PRESS ANY KEY
TO RESTART
RESTORE DEFAULTS