Filter
Top Products
AUDIO CONTROLS
JBL Synthesis
4-4
TILT EQ -3.0 to +3.0dB
Controls the amount of tilt equalization applied to the Main Zone
audio output connectors labeled Front L/R, Center, and Subwoofer.
This parameter setting affects the entire frequency spectrum with a
hinge point at 1kHz. As the setting is increased, frequencies higher
than 1kHz are boosted, while frequencies lower than 1kHz are
simultaneously cut. As the setting is decreased, frequencies higher than
1kHz are cut, while frequencies lower than 1kHz are simultaneously
boosted. The graph shown on the left of the next page illustrates
the frequency response of TILT EQ parameter settings.
Note:
When the Zone 2 command bank is activated,
pressing the remote control Blue button sets the
BASS, TREBLE, and TILT EQ parameters to +0.0dB.
TILT EQ
AUDIO CONTROLS
AUDIO CONTROLS (continued from page 4-3)
MAIN MENU
MODE ADJUST
AUDIO CONTROLS
SETUP
AUDIO CONTROLS
AUDIO CONTROLS
BASS +0.0dB
TREBLE +0.0dB
TILT EQ +0.0dB
LOUDNESS ON
BALANCE <|>
FADER <|>
ZONE2 BALANCE <|>
TILT EQ +0.0dB
-3.0 to +3.0dB
MAIN MENU
MODE ADJUST
AUDIO CONTROLS
SETUP
AUDIO CONTROLS
AUDIO CONTROLS
BASS +0.0dB
TREBLE +0.0dB
TILT EQ +0.0dB
LOUDNESS OFF
BALANCE <|>
FADER <|>
ZONE2 BALANCE <|>
LOUDNESS ON
ON
OFF
LOUDNESS ON, OFF
Controls the amount of low-frequency boost that is automatically
applied to the Main Zone audio output connectors labeled Front
L/R, Center, and Subwoofer. When set to ON, loudness
compensation is automatically applied based on volume level. As
volume level increases, the amount of boost automatically
decreases. The loudness contour is optimized for sources calibrated
to THX reference levels. When set to OFF, no loudness
compensation is applied. The graph shown on the right of the next
page illustrates the frequency response that is automatically
applied when the LOUDNESS parameter is set to ON and Main
Zone volume level is adjusted.
LOUDNESS
AUDIO CONTROLS