Filter
Top Products
MODE ADJUST PANORAMA
MODE ADJUST
SDP-5
5-11
PANORAMA
• Designed for playback of stereo and matrix-encoded sources.
• Uses proprietary JBL Synthesis algorithms to move the stereo
image outward from the front speakers, producing a wider
stereo field with greater depth.
• Depends on proper location of the listening position and front
speakers. When the front speakers are positioned close to
either side of the display device, the effect is produced over a
wider area than when the front speakers are positioned at a
large angle from the display device.
Option/ Default Possible
Parameter Setting Settings
EFFECT LVL +4dB -12 to +6dB
BASS CONTENT STEREO BINAURL, MONO, STEREO
LOW FREQ WIDTH +0 -25 to +25
SURR ROLLOFF 3.1kHz 500Hz to 20.0kHz, OFF
REAR DLY OFFSET 15ms OFF, 1 to 30ms
INPUT BALANCE <|> L< to <|> to >R
CALIBRATION Refer to the next page
OUTPUT LEVELS
CUSTOM
Listening mode menu option and parameter descriptions begin on page 5-28.
PANORAMA CALIBRATION
• The PANORAMA listening mode must be calibrated to take full
advantage of its effects.
• For best results, it is recommended to center the primary
listening position between the front left and right speakers as
shown in the illustration centered at the top of page 5-13.
Otherwise, the PANORAMA listening mode will be calibrated
with various results.
Option/ Default Possible
Parameter Setting Settings
SOURCE LEFT & RIGHT RIGHT, LEFT & RIGHT, LEFT
SPEAKER ANGLE 30deg 10 to 90deg
LISTENER POS +0 -127 to +127
Calibration parameter descriptions begin on the next page.
To calibrate the PANORAMA listening mode:
1. Remove all obstructions between the speakers and the primary
listening position.
2. Make sure the distances between the speakers and the primary
listening position are properly measured. Then, enter these
distances on the SPEAKER DISTANCES menu.
3. Sit in the primary listening position. If the primary listening
position is not centered between the front left and right
speakers, set the LISTENER POS parameter to compensate for
the difference. Refer to the LISTENER POS parameter
description on the next page for assistance.
. . . Panorama Calibration continues on page 5-12
MODE ADJUST PANORAMA CALIBRATION