Filter
Top Products
Getting Started
SDP-5
1-5
REMOTE CONTROL BATTERY INSTALLATION
The remote control requires two AA batteries that should be replaced as needed. It is recommended to use Alkaline batteries, which last longer
without leaking. When the batteries are low on power, the remote control enters a low-voltage condition that prevents it from operating the
SDP-5. When this occurs, follow the instructions below to replace the batteries. Normal operation will resume when the new batteries are
installed.
To replace the remote control batteries:
1. Locate the battery compartment on the back of the remote control. Then, remove the battery compartment cover as shown in the figure
below (left). To do this, press the tab attached to the cover. When the tab is pressed, pull the cover away from the remote control.
2. Remove old batteries inserted in the compartment (if applicable).
3. Insert two AA batteries in the compartment as shown in the figure below (center). Make sure the batteries are correctly inserted observing
the proper polarity.
4. When new batteries have been installed, close the battery compartment cover as shown in the figure below (right). To do this, align the
cover with the guide on the back of the remote control. When the cover is aligned, press the cover until it "snaps" into place.
5. Dispose of the old batteries (if applicable).