Filter
Top Products
74
CD-R/RW MASTER RECORDER CR500 (MENU mode: SYSTEM SETUP menu)
Basic procedure for using the "SYS SETUP" menu
The basic procedure for using the "SYS SETUP" menu is as described below, though the actual
procedure may differ depending on menu. It is assumed that a blank or recorded CD-R/RW disc
is set to the disc drive.
1) While the recorder is stopped, press the [ENTER/YES] key.
The unit enters the MENU mode and the MENU list screen as below is shown.
Initially, "SYS SETUP " is highlighted.
2) While "SYS SETUP " is highlighted, press the [ENTER/YES] key.
The display now shows the SYS SETUP menu screen.
Initially, "Default file name " is highlighted.
3) Use the [MENU] dial to select the desired menu item and press the [ENTER/YES]
key.
The display now shows the first level screen of the selected menu item.
Selecting a menu item with " " on the right goes down to the next level screen.
If you select a menu item without " ", the current setting flashes and you can
now make selection on the current level screen.
For details of each item, see the next and following pages.
• Example of a menu item which has the next level screen
(Selecting the item goes down to the next level screen.)
• Example of a menu item of which you can make setting on the first level screen
(When you select the item, the current setting flashes.)
Pressing the [EXIT/NO] key goes up the level one by one. Therefore, you can
finally exit the MENU mode by pressing the [EXIT/NO] key repeatedly. Also,
you can directly exit the MENU mode by pressing the [STOP/HOME] key.