Filter
Top Products
65
CD-R/RW MASTER RECORDER CR500 (Playback/Locate)
<Example when you select "[START]">
<Example when you select "[END]">
3) Use the numeric ([MEMORY]) keys or
[MENU] dial to enter the desired number.
Use the [SKIP/CURSOR ]] keys to
move the cursor point (flashing point).
Use the numeric ([MEMORY]) keys or [MENU]
dial to enter the desired value of the
flashing point.
By pressing the [CLEAR/+10] key repeatedly,
you can reset time to 00m00s000ms.
4) After entering the desired time, press the
[ENTER/YES] key.
The start (or end) time is replaced with the
new value.
5) After editing, move the cursor to "<SAVE>"
and press the [ENTER/YES] key.
The display returns to the Home screen of
the MEMORY PLAY mode.
<Note>:
Do not forget to execute the
save operation above. Otherwise, the
editing is cancelled.
Editing the start time/end time using the digital scrub function
You can edit the playback start time and end time by using digital scrub function.
The following description assumes that one or more memory banks has audio data and the dis-
play shows the Home screen of the MEMORY PLAY mode.
1) Press the [SHIFT] key to turn on the Shift mode,
and specify the memory bank whose data you
want to edit by pressing the corresponding
numeric key in the [MEMORY] key group.
For example, if you press the [1/space] key,
the display changes to show the setting
screen for memory bank 1 (MEMORY 1).
To edit the playback start time, select
"<SCRUB-S>".
To edit the playback end time, select
"<SCRUB-E>".
Pressing the [ENTER/YES] key brings up the
waveform screen of audio data.
While this screen is shown, you can scrub
audio for fine adjustment of time using the
[MENU] dial.
" " on the screen indicates the playback
start (or end) time.
2) Move the cursor to "<SCRUB-S>" or
"<SCRUB-E>", and press the [ENTER/YES]
key.
<Example when you select "<SCRUB-S>">
flashing
flashing