Filter
Top Products
22
CD-R/RW MASTER RECORDER CR500 (Preparation before using the CR500)
Adjusting display contrast
The display contrast of the unit is adjusted suitably when shipped. If you want to change
the contrast, follow the procedure described below.
EXIT/NO
SHIFT
PUSH
MENU/ENTER/YES
SKIP/CURSOR
STOP/HOME
RECORD PLAY
REWIND
F FWD
PQRS
REC END
ABS 0
0
symbol TUV WXYZ
8
2
5
CONTRAST
FILE SEL
space ABC DEF
EDIT TIME
CLEAR
1
4
7
MEMORY SET
MEMORY
GHI JKL MNO
9
3
6
DISPLAY
LOCATE
+10
DIR SEL
REC RDY
ACCESS
PLAY MODE
P
ROGRAM SET
REPEAT
O
PEN/CLOSE
[SHIFT] key
[DISPLAY/
CONTRAST
] key
1) Press the [SHIFT] key to turn on the [SHIFT] indicator, followed by the [DISPLAY/
CONTRAST
]
key.
The popup message as shown below appears on the display and you can now adjust the
display contrast.
[MENU] dial / [ENTER/YES] key
2) While the popup message above is shown, rotate the [MENU] dial to adjust the display
contrast.
Rotating the dial clockwise weakens the contrast, while rotating it counterclockwise
strengthens the contrast.
<Weak contrast> <Strong contrast>
3) After adjusting the contrast, press the [ENTER/YES] key to confirm your setting.
The adjusted display contrast is now effective and the popup message above is dismissed.
<Note>:
The contrast setting remains even if you turn off the power.
If you initialize the system memories from the "Sys initial Memories>" or
<"Sys Default Set>" item of the "SYS SETUP" menu in the MENU mode, the contrast
is initialized to the factory preset.