Filter
Top Products
AGILENT 35670A
Supplemental Operator’s Guide
21
• Press the [CHANNEL 1 234] softkey (F1) until 1 is highlighted.
• Press the [TIME CHANNEL 1] softkey (F5)
• Press the [Scale] hardkey.
• Toggle the [AUTOSCALE ON OFF] softkey (F1) until ON is highlighted..
• Press the [Active Trace] hardkey.
• Press the [B] softkey (F1)
• Press the [Meas Data] hardkey.
• Press the [CHANNEL 1 2 34] softkey (F1) until 2 is highlighted.
• Press the [TIME CHANNEL 2] softkey (F5)
• Press the [Scale] hardkey.
• Toggle the [AUTOSCALE ON OFF] softkey (F1) until ON is highlighted.
Arming Dual Channel Time Measurements
To manually arm a dual channel time measurement, proceed the same as for the
single channel case:
• Press the [Trigger] hardkey.
• Select the [ARM SETUP] softkey (F7)
• Select the [MANUAL ARM] softkey (F2)
• Press the yellow [Start] hardkey to begin the measurement.
• Press the [Trigger] hardkey.
Then to arm a single time record,
• Press the [ARM] softkey (F9)
One time record will be captured and displayed. To capture another time record,
• Press the [ARM] softkey (F9) again.
Triggering a Dual-Channel Time Measurement
Either channel may be monitored to initiate a trigger for a measurement. Setting up
the trigger event is the same as for single channel time waveforms, except that
channel 1 or channel 2 must be selected as the trigger. To specify the trigger
channel, proceed as follows:
• Press the [Trigger] hardkey.
• Press the [CHANNEL 1 234] softkey (F3) until 1 is highlighted.
This sets up the analyzer to trigger off an event on channel 1. To set up channel 2 as
the trigger channel, do the following:
• Press the [Trigger] hardkey.
• Press the [CHANNEL 1 2 34] softkey (F3) until 2 is highlighted.