Open as PDF
TA-500 user manual
Flying a single TA-500 cabinet using M10 eyebolts
The simplest method of flying a TA-500 cabinet is with a pair of M10 shoulder eyebolts on
the top, using a third eyebolt on the rear of the cabinet to tilt the cabinet.
1. Remove the two countersunk M10 screws located towards the front of the cabinet.
2. Replace these with M10 shoulder eyebolts with a minimum thread length of 20mm (3/4”)
3. Angle the cabinet as necessary using the third eyebolt position on the rear of the cabinet.