Filter
Top Products
7–Recorder Functions
TASCAM DP-004 69
Punching in and out
Punching in/out is a technique to replace a part of an
already recorded track.
Start playback and when you reach the part that you
want to replace, switch to record (punch in), then
switch back to playback (or stop) when you nish
the part that you want to replace (punch out).
1 Decide what part of the track you plan to replace
and choose a point to begin where the new
recording can sit well with the existing recording.
2 Press the REC key of the track that you plan to
replace part of to start record standby (REC
indicator blinks).
3 Start playback before the part of the track that you
want to replace.
4 Press the record (–) key to start recording (punch
in) when you reach the part. Play or sing what you
want to record.
5 Press the playback (Á) key to switch to playback
(punch out) when you finish the replacement
recording.
TIP
You can also press the stop (ª) key to punch out at the
end of the replacement recording.
Bouncing tracks
Use this unit’s bounce function to mix already
recorded tracks (1–4) down to one or two tracks.
Multitrack tape recorders can only bounce to an
open track (in other words, they can not record to a
track that is also a source of the mix). For example,
tracks 1–3 could be bounced to track 4, but tracks
1–4 could not be bounced to track 1. This unit,
however, does not have this limitation. You can
bounce tracks 1–4 as a stereo mix to tracks 1 and 2
(stereo bounce), or bounce tracks 1–4 as a mono mix
to track 1 (mono bounce).
NOTE
Inside this unit, a mixdown is made to create a mix
master that is recorded to the designated tracks.