Filter
Top Products
66 TASCAM DP-004
6–Basic Recording
Undoing operations (undo)
This unit allows you to undo an operation or
recording that did not work as planned or was
otherwise unsatisfactory. Undo can be used on many
ordinary operations, including editing and recording
operations. This unit has two types of undo
functions. Single undo can be used with a simple
key press, while multi-undo allows you to return to
and undo a specic past operation.
Undoing the last operation (single undo)
Press the UN/REDO key to return to the state before
the last operation was conducted. After doing this,
the UN/REDO indicator lights, showing that redo (see
below) is possible.
NOTE
The UN/REDO indicator lights when the unit state is
not the last editing or recording operation conducted
(when undo has been used).
Cancelling an undo operation (redo)
Press the UN/REDO key when it is lit to return to the
state of the last operation. The UN/REDO indicator
turns OFF.
NOTE
If single undo is used when multi-undo (described below)
has already been used to return the unit to a previous
state, it will go one more step backward. If you press the
UN/REDO key again to redo the step, the single undo
operation is cancelled, and the previous multi-undo state
is restored. In this case, the unit is not restored to the
most recently conducted operation, so the UN/REDO
indicator remains lit because further redo operations
are possible.
Undoing a previous operation (multi-undo)
1 Press the UN/REDO key while pressing and holding
the stop (ª) key to open the
HISTORY
screen.
This screen shows the operation history as a list.
Each operation in the list is called an “event.” The