Filter
Top Products
13–Specifications & Messages
TASCAM DP-004 107
Messages Meaning and remedy
No Disk Space
You tried to create a song, but there is not enough space on the partition to create a song ("Creating a new
song" on page 49). Free up some space and try again.
No Master Trk
You have tried to use a non-existent master track as the source in a track cloning operation ("CLONE
TRACK" on page 87). Select another source or master the song and try again.
No Song
You are trying to load a song from a partition that has no songs on it ("Loading a saved song" on page 48).
Change partitions ("Selecting the active partition" on page 47).
No Undo History
There are no actions to be undone. See "Undoing operations" on page 66.
Not Stopped
The transport is moving (not stopped, but playing back, recording, etc.) and you have pressed a key such as
the UN/REDO key which cannot be used until you press STOP.
Now Recording
You are trying to perform an action which cannot be done while recording.
Same Track
You cannot clone a track to itself. ("CLONE TRACK" on page 87.)
Song Protected
The song is protected ("Protecting songs" on page 53) and you are trying to change it (record or edit, etc.).
Unprotect the song.
Too Many songs
You have 250 songs on one partition. You must delete some before you can create another song.
Track Full
You are trying to import a file from the FAT partition to a track that has already been recorded to ("Importing
tracks" on page 97). You can only import to a blank track.
Trk Too Short
You are trying to master with the OUT point at the zero position ("Mixdown" and "Mastering" on page 62). Set
the OUT point ("Setting IN and OUT points" on page 73) and try again.
No SD Card
Insert an SD card after turning off the unit.
I
nvalid Card
Insert another SD card after turning off the unit, or format the card by MENU ®
CARD
®
FORMAT
.
Protected Card
To record or edit, turn off the unit and un-protect the SD card.
Card Full
The SD card is full during recording.
Trk Edit Fail
Save the song and turn the unit off and then on, and perform track edit again.
Battery Empty
Replace the batteries with new ones or use a PS-P520 AC adapter (sold separately).