Filter
Top Products
50
Random Music Sensor (RMS)
Operation
The RMS function allows you to program
the desired selections in the desired order.
For the operation, program numbers must
be written on the tape.
This operation can be performed only with
the remote commander.
1 Designate the desired selection by
pressing the numeric button(s) in
the stop mode.
The selection numbers can be
specified from 1 to 99.
a) Lights
2 Press the ENTER button.
a) Indicates the playing order.
b)The RMS indicator lights after
programming the first selection.
3 Repeat step 1 and 2.
A maximum of 60 selections can be
programmed.
4 Press the 3 (play) button.
The programmed selections are
played back in the designated order.
To stop RMS play
Press the 7 button.
To check the programmed
selections
Press the CHECK button on the remote
commander. Each time you press the
CHECK button, the programmed selections
appear in the designated order.
To add a selection to the program
Once the RMS play starts, you cannot add
a selection. To add a selection, first stop
the RMS play, and program new
selection(s) by following the procedure
described above.
To delete the selection you
programmed last
Press the CLEAR button.
However, when checking the programmed
selection, the CLEAR button cannot be
used.
To cancel the entire program
In the stop mode: Press the 7 button once.
In the RMS play mode: Press the 7 button
twice.
The program is also erased when the
power is turned off.
1
4
1
1 2 3
4 5 6
7 8 9
0
2
ENTER
AMS
PGM NO
a)
2
b)
STEP
RMS
a)
4
CLEAR
CHECK
7
3
Various Playback
Operations