Filter
Top Products
18
)
8
1¡$›
•¶
£7
1Turn on the power.
2 Press 0OPEN/CLOSE.
The indicator appears on the
display.
3 Insert the cassette.
A)Insert the cassette beyond the silver
line.
B)Tab facing fowards you.
C)Window side up.
4 Press 0OPEN/CLOSE.
The indicator appears on the
display.
To remove the cassette
Press 0OPEN/CLOSE.
On a digital audio tape
Only the digital audio tape made
especially for DAT deck is required.
Unlike a conventional analog audio
cassette tape, a digital audio tape can be
used only one side.
• Digital audio tape is designed to avoid a
dust. Do not open the inside of the tape.
• The hole at the back of a tape is a
detector slot. Do not cover the slot.
Notes
• When you turn on the power, the 8
indicator flashes for a moment in the
display window. During this period, no
buttons other than the 0OPEN/CLOSE
and 3 buttons are operative. Wait until
flashing stops and the 8 indicator goes
off.
• When inserting the cassette, do not push
the cassette compartment closed. Be
sure to use the 0OPEN/CLOSE button.
On the sampling frequency
When a cassette is inserted and a source
program is played back, the sampling
frequency (48 kHz, 44.1 kHz or 32 kHz) of
the source program appears in the display
window.
To prevent accidental erasure Å
When a recording is made, any previously
recorded signal will be erased
automatically. To prevent accidental
erasure, set the safety tab to the position
shown in the illustration. With the hole
open, rewriting sub codes cannot be
performed.
A)Recording is impossible (with the hole
open).
B)Recording is possible (with the hole
covered).
Cassette
Loading
2, 4
1
3
1
2
3
A)
B)
C)
4
A
A)
B)
)
OPEN/CLOSE
)
OPEN/CLOSE
POWER