Filter
Top Products
29
Things that can
be done
Locating a
selection (AMS
function)
Listening to the
first portion of
selections
sequentially (Music
Scan)
Choosing a
selection directly
Programming
desired selections
in a desired order
(RMS play)
Skipping the
portion not desired
Looking for the
position at which
the recording or
playback ends
Required sub
code(s)
Start ID
Start ID
Start ID/Program
number
Start ID/Program
number
Skip ID/Start ID
End ID
Sub Codes
2)
When recording new material on a
recorded tape, you can write an end ID at
the end of the re-recorded portion. This will
help you easily find the position to start
recording the next time when you want to
record other material onto the same tape.
A)Selection
B)Blank
C)Recorded tape
D)When recording new material onto
the same tape.
E)End ID
F) Portion where you have not made a
second recording (This first recording
has not be erased.)
3)
When an end ID which has been written is
detected during locating selections or
rehearsal playback of start ID or skip ID,
the unit stops at the beginning of the end
ID.
A)Selection
B)End ID
C)The position at which the tape stops.
Absolute time
The absolute time indicates the position of
the tape, giving the time elapsed from the
beginning. The absolute time is recorded
automatically at the same time the audio
signal is recorded. It cannot be re-
recorded. The absolute time allows you to
confirm the elapsed time from the
beginning of the tape.
When using the sub codes
E
2)
3)
A)
A)
A) A) A)
B)
C)
D)
A)
A) A)
F)
E)
A)
A)
A)
B)
C)