Filter
Top Products
92
GB
Optional components
There is no sound.
• Refer to General item “There is no sound.”
(page 87) and check the condition of the system.
• Connect the component properly (page 84) while
checking:
– if the cords are connected properly.
– if the cord plugs are firmly inserted all the way.
• Turn on the connected component.
• Refer to the operating instructions supplied with
the connected component and start playing.
• Check if proper function is selected.
The sound is distorted.
• Set the volume of the connected component
lower.
• Press FUNCTION repeatedly until “VIDEO”
appears, and press MENU/NO to select “SAT?”,
then press ENTER.
If the system still does not
operate properly after performing
the above measures, reset the
system as follows:
1 Disconnect the mains lead.
2 Reconnect the mains lead.
3 Press ?/1 to turn on the system.
4 Press SPEAKER OUT MODE and SOUND
FIELD + on the DVD player and move
SA-CD/DVD lever on the DVD player to x at
the same time.
The system is reset to the factory settings except
for DVD settings. You should set the settings
you made, such as the preset stations, clock, and
timer.
To return the DVD setup to the
default settings*, perform reset
as follows:
1 Press DVD SETUP in stop mode.
2 Press v or V repeatedly to select “RESET”,
then press ENTER.
3 Press v or V repeatedly to select “YES”,
then press ENTER.
It takes a few seconds to complete. Do not
press ?/1 when resetting the system.
* Except for Parental Control settings
This system has a Self-diagnosis display
function to let you know if there is a system
malfunction. The display shows a code made up
of three or five letters and a message alternately
to show you the problem. To solve the problem
refer to the following list. If any problem
persists, consult your nearest Sony dealer.
C11/Protected
The MD is protected against erasure.
cRemove the MD and slide the tab to close the slot
(page 42).
C12/Cannot Copy
You tried to record a disc with a format that the
system does not support, such as a CD-ROM.
cRemove the disc and turn off the system once,
then turn it on again.
You tried to record sound that cannot be digitally
recorded with this system from a connected optional
component.
cSwitch the digital audio output of the optional
component to PCM mode.
C13/REC Error
Recording could not be performed properly.
cMove the system to a stable place, and start
recording over from the beginning.
The MD is dirty or scratched, or the MD does not
meet the standards.
cReplace the MD and start recording over from the
beginning.
C13/Read Error
The MD deck cannot read the disc information
properly.
cRemove the MD once, then insert it again.
Self-diagnosis display