Filter
Top Products
10
GB
6 Connect the t INPUT jack of your TV
to the T LINE-TV jack on the DVD
player with the SCART cord (not
supplied).
When you connect using the SCART cord,
check that the TV conforms to S video or
RGB signals. If the TV conforms to
S video, change the input mode of the TV to
RGB signals. Refer to the operating
instructions supplied with the TV to be
connected.
When using a TV
Turn on the TV and select the video input so that you
can view the pictures from this system.
When connecting a video deck
Connect the TV and the video deck using video and
audio cords (not supplied) as shown below.
If you connect a video deck between this system and the
TV, you may experience video leakage when watching
the video signal from this system. Do not connect a
video deck between this system and the TV.
Note
Do not place the TV on this system.
Tip
To listen to TV, press FUNCTION repeatedly to select
“TV”.
7 Connect the mains lead on the DVD
player to mains on the MD deck.
8 Connect the mains lead on the MD deck
to mains.
If the plug does not fit your wall socket,
detach it from the plug (only for models
equipped with an adapter).
To turn on the system, press
?/1.
Note
When you turn on the system, the disc is not pulled into
the disc slot until “No Disc” appears in the display. Do
not attempt to push in the disc until “No Disc” appears,
as this may cause malfunction.
To connect optional components
See page 84.
Inserting two size AA (R6)
batteries into the remote
Notes
• If you do not use the remote for a long period of time,
remove the batteries to avoid possible damage from
battery leakage and corrosion.
• See page 109 for the location of the remote sensor.
Tip
With normal use, the batteries should last for about six
months. When the remote no longer operates the
system, replace both batteries with new ones.
TV
Video deck System
Do not connect
directly.
e
e
E
E