Filter
Top Products
52
GB
You can create titles for your recorded MDs,
tracks, and groups as follows.
After recording
Use Name Function.
You can input a total of approximately
1,700 characters for the disc title, track titles and
group titles on a single MD.
When labelling an MD recorded using
the Group Function, be sure to label the
disc with the Group Function on so as
not to rewrite the group management
information by mistake.
For details on the group management
information, see “How is group information
recorded?” on page 51.
1 Press FUNCTION repeatedly to switch
the function to MD.
2 Perform the following procedure
depending on what you want to label:
To label a track
Press . or > repeatedly until the
desired track number appears, then press
NAME EDIT/SELECT.
To label an MD
Press NAME EDIT/SELECT while the
total number of tracks (or groups when the
Group Function is on) is displayed.
To label a group
Press MD GROUP repeatedly until
“GROUP ON” appears, then press GROUP
SKIP repeatedly until the desired group
appears. Press NAME EDIT/SELECT
while the total number of tracks within the
desired group is displayed.
3 Press NAME EDIT/SELECT to select
the desired type of character.
4 Enter a character.
5 Repeat steps 3 and 4 to enter the rest of
the name.
6 Press ENTER.
To change the character
In step 3 or 4, press m or M repeatedly until
the character to be changed flashes, press
CLEAR to erase the character, then repeat steps
3 and 4.
To add a character
After steps 1 and 2, press m or M repeatedly
until the cursor comes to the point you want to
add a character, then proceed to step 3.
Labelling an MD/group/
track
— Name Function
Character type Select
Alphabet (upper cases)/
blank space/symbols
Selected AB
Alphabet (lower cases)/
blank space/symbols
Selected ab
Numbers Selected 12
Character type Do this
Alphabet Press the corresponding
letter button repeatedly until
the character to be entered
flashes, then press M.
Numbers Press the corresponding
number buttons.
Blank space Press 10/0.
´ – / , . ( ) : ! ? Press 1 repeatedly.
& + < > _ = “ ; # $
% @ `
Press 1, then press . or
> repeatedly.
The cursor starts flashing.