Filter
Top Products
MD – Recording
43
GB
Recording for long times
This system has two long time recording modes:
LP2 and LP4 (MDLP recording).
Press REC MODE on the MD deck to select the
recording mode. Refer to the pages about
recording (pages 43, 45 and 46).
MDs recorded in MDLP Stereo mode are played
back only on the system with the following
marks.
MDs recorded in MDLP Stereo mode cannot be
played back on the system that does not support
MDLP mode.
Notes
• Even if the recording mode is set to “MONO”, the
sound from the speakers are output as recorded in the
source (in stereo when recording the stereo source).
• Some MDs recorded in MDLP Stereo mode are
edited so that “LP:” is displayed to indicate that
playback is not possible when an attempt is made to
play back these MDs on a system that does not
support MDLP mode. However, this system supports
MDLP mode, so “LP:” is not displayed when these
MDs are played back.
• When playing back these MDs on a system that does
not support MDLP mode, set the transfer mode
during SonicStage check-out to “Stereo Transfer”. If
transfer is performed in LP2 or LP4 mode, you will
be unable to play back these MDs on a system that
does not support MDLP mode.
Tips
• LP4 stereo mode (4× long time recording mode)
achieves a long stereo recording time by use of a
special compression system. When placing emphasis
on sound quality, Stereo recording or LP2 stereo
recording (2× long time recording mode) is
recommended.
• You can mix the recording mode in an MD.
• The selected recording mode is kept even after
recording has finished. To change the recording
mode, press REC MODE on the MD deck
repeatedly.
You can record a whole CD on an MD. You can
select the recording time by switching the
recording mode.
Use buttons on the MD deck for the operation.
1 Load a recordable MD.
2 Load a CD you want to record.
3 Press REC MODE repeatedly to select
the recording mode.
Select the desired recording time.
4 Press MODE repeatedly until “CDtMD
SYNC” appears.
5 Press ENTER/START.
“Press START” flashes.
The MD deck stands by for recording and
the DVD player pauses for play.
6 Press ENTER/START while “Press
START” flashes.
Recording starts.
When the recording is completed, the DVD
player and the MD deck stop automatically.
To stop recording
Move MD lever to x.
Recording tips Recording a CD on an MD
— CD-MD Synchro Recording
Recording time Select
(Recording mode)
Standard no indication (stereo)
Double LP2 (LP2 stereo)
Quadruple LP4 (LP4 stereo)
Double
(change the stereo
signal to monaural)
MONO (monaural)
continued