Filter
Top Products
ENGLISH
72
• There may be a slight time delay between the video and audio signals in case that some video playback equipments may
process the video signals later than the audio signals due to signal processing procedure, etc.. Should this happen, you can
adjust the time delay of audio signals to synchronize the sound with the picture.
• The time delay can be adjusted within the range of 0 ~ 200 msec.
When selecting the AV Sync
• When the source components that cannot support the HD audio signal format (such as Dolby Digital Plus, Dolby TrueHD,
DTS-HD High Resolution Audio, DTS-HD Master Audio, etc.) are connected to the HDMI IN of this receiver, some
components may not output any audio signals from its HDMI OUT.
In this case, you should set the HD Audio to Off to play the audio signals other than the HD audio signals. (For details on the
playable audio signal format, refer to the operating instructions of the source component.)
On : To play the audio signals (including the HD audio signals).
↕
Off : To play the audio signals other than the HD audio signals.
When selecting the HD Audio
• To turn on the component connected to the DC TRIGGER OUT jack when the input source is selected, you should set the
DC Trigger to On for this input source.
Off : To turn off the DC trigger function.
↕
On: To turn it on.
• For details, refer to "CONNECTING DC TRIGGER OUT" on page 15.
• You can select the desired of the listening positions at which the Auto Setup Trinnov Optimizer has been completed
depending on your tastes or program source, etc.
• When you want to listen in the settings you make manually on the Speaker Configuration, the Crossover Frequency, the
Speaker Distance and the Speaker Level Trim menus, you should set the Trinnov Position to "None".
■Note :
• The Trinnov Room EQ, the Trinnov Spatial Mode and the Trinnov Remapping settings can be set when the Trinnov Position
is not set to "None".
→ None : To listen in the settings you make manually.
↕
1: To listen in the settings memorized into the memory of position 1 by the Auto Setup Trinnov Optimizer.
↕
2: To listen in the settings memorized into the memory of the position 2.
↕
→ 3: To listen in the settings memorized into the memory of the position 3.
When selecting the DC Trigger
When selecting the Trinnov Position
Continued
• The Trinnov Room EQ is a kind of room equalizer for your speakers. According to the acoustic characteristics of your room
measured by the Auto Setup Trinnov Optimizer, the Trinnov Room EQ automatically adjusts the frequency response of your
speakers.
→ None : When turning off the Trinnov Room EQ.
↕
Flat : To adjust the frequency response of all speakers to the flattest response.
↕
A.Phile 1 : To adjust the frequency response of the speakers other than the front speakers to match the characteristics of the
↕ front speakers.
A.Phile 2 : To adjust only the low frequency response of all speakers to correct the acoustic characteristics of your room.
↕
→ Natural : To adjust the frequency response of all speakers with a modest boost below 200 Hz and a slight cut above 10 kHz.
When selecting the Trinnov Room EQ
R-972(A)_ENG_090225:R-972(A) 2009-04-15 오 9:01 페이지 72