Filter
Top Products
ENGLISH
30
Changing the transmission signal
• This remote control can emit not only the infrared beams
which the conventional remote control uses but also the
RF(Radio Frequency) beams which are stronger than
those.
• When you want to control this receiver from longer
distance even if there are obstacles such as walls,
furniture, etc. in the way, change the transmission signal
into "RF"(Radio Frequency).
■Notes:
• When the RF remote antenna is not connected, remote
operation will become unreliable. (For details, refer to
"CONNECTING RF REMOTE ANTENNA" on page 14.)
• If the transmission signal mode is set to "RF" (Radio
Frequency), this remote control cannot control other
audio and video components.
• In this case, to control the component, connect the IR
emitter to the IR OUT jack. (For details, refer to
"CONNECTING MULTI-ROOM SYSTEM KIT" on page
15.)
1. Press and hold down the ENTER button and the
AUDIO button for more than 2 seconds.
• Then "LEARN" is displayed on the LCD screen for
several seconds.
■Note:
• During setting operation, to exit from the setting mode,
press any of the DEVICE buttons.
2. While "LEARN" is displayed, press the CURSOR
UP(▲)/DOWN(▼) buttons to select the
transmission signal mode("RF-IR"), then press
the ENTER button.
• Then "RF" (or "IR") is displayed.
• If "RF" (or "IR") goes off, start again from the above step 1.
3. While "RF" (or "IR") is displayed, press the
CURSOR UP(▲)/DOWN(▼) buttons to select
the desired transmission signal, then press the
ENTER button.
4. To pair up this remote control and the receiver,
press the TUNING UP(+) button and the
ENTER/MEMORY button simultaneously on the
receiver.
5. While "RF REMOCON PAIRING MODE" is
displayed, press the ENTER button, aiming at the
receiver.
• Each time the CURSOR UP(▲)/DOWN(▼) buttons are
pressed, the mode changes as follows :
"RF" : This remote control emits the RF(Radio Frequency)
beams which are stronger than the infrared beams.
"IR" : This remote control emits the infrared beams which
the conventional remote control uses.
• Then "OK" is displayed.
• "RF REMOCON PAIRING MODE" is displayed for
several seconds on the display of the receiver.
• If "RF REMOCON PAIRING MODE" goes off, press
these buttons again.
• Then "PAIRING SUCCESS" is displayed.
■When "RF" is set to.
↕
R-972(A)_ENG_090225:R-972(A) 2009-04-15 오 9:00 페이지 30