Filter
Top Products
ENGLISH
70
When selecting the HDMI Assign
When selecting the Video Assign
When selecting the Audio Assign
• You should assign the connected HDMI INs to the desired of VIDEO 1 ~ VIDEO 5.
(For details, refer to "CONNECTING VIDEO COMPONENTS" on pages 6 ~ 8.)
• You can select the desired of HDMI 1 ~ HDMI 4.
■Note :
• In such a case that a HDMI IN is assigned to two input sources or more, when these input sources are selected, the
uncompressed digital video signals (and digital audio signals when the HDMI Audio Output is set to On) input into the same
HDMI IN can be output from the HDMI MONITOR OUT of this receiver.
• You should assign the connected COMPONENT VIDEO INs to the desired of VIDEO 1 ~ 5.
(For details, refer to "CONNECTING VIDEO COMPONENTS" on pages 6 ~ 8.)
• You can select the desired of COMP 1 ~ 3.
■Note :
• In such a case that a COMPONENT VIDEO IN is assigned to two input sources or more, when these input sources are
selected, the component video signals can be viewed from the same COMPONENT VIDEO IN.
When selecting the Video Mode
• You should assign the connected DIGITAL INs to the desired of CD and VIDEO 1 ~ VIDEO 5.
(For details, refer to "CONNECTING DIGITAL INS AND OUT" on page 10.)
• You can select the desired of Optical 1 ~ 5 and Coaxial 1 ~ 2.
■Note :
• In such a case that a DIGITAL IN is assigned to two input sources or more, when these input sources are selected, the digital
audio signals can be heard from the same DIGITAL IN.
Continued
• You can select the video input signal to be output from the MONITOR OUTs depending on the Monitor Output settings.
(For details, refer to "When selecting the Monitor Output" on page 59.)
→ Auto : When there are multiple video input signals, the video input signals are detected and the video input signal to be output
from the MONITOR OUTs is selected automatically in the priority order of them :
"HDMI" > "COMPONENT" > "S-VIDEO" > "(composite) VIDEO"
HDMI : The signal that is input into the HDMI IN connector is always played. The HDMI video input signal is output from the
HDMI MONITOR OUT only.
Component : The signals that are input into the COMPONENT IN jacks are always played.
The component video signals are converted and output from the MONITOR OUTs.
S-Video : The signal that is input into the S-VIDEO IN jack is always played.
The S-Video signal is converted and output from the MONITOR OUTs.
→ Composite : The signal that is input into the (composite) VIDEO IN jack is always played.
The composite video signal is converted and output from the MONITOR OUTs.
• For details on the video input signal to be output, refer to "Video conversion" on page 7.
3. Press the CURSOR LEFT(◀)/RIGHT(▶) buttons to set the selected item as desired.
↕
↕
↕
↕
R-972(A)_ENG_090225:R-972(A) 2009-04-15 오 9:01 페이지 70