Filter
Top Products
23
• If any of buttons fails to operate as they should, start from
the step 1 again to enter the correct setup code.
■Note :
• Manufacturers may use different setup codes for the
same product category. For that reason, it is important
that you check to see if the code you have entered
operates as many controls as possible. If only a few
functions operate, check to see if another code will work
with more buttons.
6. Operate the component using the corresponding
function buttons.
4. While "PRESET" is displayed, press the ENTER
button to store the setup code.
5. Operate the component using the corresponding
function buttons.
6. Repeat the above steps 1 to 5 for each of your
other components.
1. Turn on the component you want to operate.
2. Perform the steps 3 and 4 in "Entering a setup
code" procedure on page 22 to select the setup
code mode ("CODE").
3. While "PRESET" is displayed, search a setup
code, aiming the remote control at the remote
sensor on the component.
7. Repeat the above steps 1 to 6 for each of your
other components.
Searching a setup code
• Each time the CURSOR UP(▲)/DOWN(▼) buttons are
pressed, the setup code is selected one by one.
• If the selected code is correct, your component will be
turned off.
• When your component is not turned off, repeat this step
until you find one that works.
• In addition to enter a setup code using "Setup Code
Table" on page 85, it is also possible to search through
all the codes that are stored in the library of this remote
control.
• Then "OK" is displayed on the LCD screen.
• If any of buttons fails to operate as they should, start
from the step 1 again to find the correct setup code.
ENGLISH
R-972(A)_ENG_090225:R-972(A) 2009-04-15 오 9:00 페이지 23