Filter
Top Products
ENGLISH
26
Programming a macro function
Example: When playing a DVD on the DVD player
connected to VIDEO 2 jacks of this receiver.
①. Press "AUDIO" button to control this receiver.
②. Press "POWER ON" button to turn this receiver on.
③. Press "VIDEO 2(7)" button to select the desired input
source.
④. Press "DVD" button to control the DVD player.
⑤. Press "POWER ON" button to turn the DVD player
on.
⑥. Press "PLAY (▶)" button to start playback.
• Each time the operation buttons are pressed, the
programmed order is displayed.
• The macro function enables you to program a series
of button operations(up to 15) on this remote control
into a single button.
• You can store up to three separate macro command
sequences into "M1", "M2" and "M3" buttons.
• Then "M1" is displayed on the LCD screen for several
seconds.
• During macro setting operation, pressing any of the
DEVICE buttons cannot exit from the macro mode.
• Each time the CURSOR UP(
▲)/DOWN(▼) buttons are
pressed, "M1", "M2" or "M3" is selected.
• Then "SEL" is flickering.
• If "SEL" goes off, start again from the above step 1.
1. Perform the steps 3 and 4 in "Entering a setup
code" procedure on page 22 to select the macro
mode ("MACRO").
2. While "M1" is displayed, press the CURSOR
UP(▲)/DOWN(▼) buttons to select the MACRO
button to be programmed into, then press the
ENTER button.
3. While "SEL" is flickering, press the operation
buttons you want to program in order.
4. Press any of the MACRO buttons (M1~M3) to
complete the programming.
• Then "OK" is displayed.
■To erase a macro program
• When erasing a macro program, perform the above
steps 1, 2 and 4, but ignore the step 3.
■To change a macro program
• When a new macro program is stored into a MACRO
button with performing the above steps 1 to 4, the
previous macro program is erased from the memory of
the MACRO button.
R-972(A)_ENG_090225:R-972(A) 2009-04-15 오 9:00 페이지 26