Filter
Top Products
7
■Notes :
• For stable signal transfer, we recommend using HDMI cords that are a maximum of 5 meters in length.
• Among the components that support HDMI, some components can control other components via the HDMI connector.
However, this unit cannot be controlled by another component via the HDMI connector.
• The audio signals from the HDMI connector (including the sampling frequency and bit length) may be limited by the
component that is connected.
• The video signals will not be output properly if a component incompatible with HDCP is connected.
• If the resolutions of the video signals which are output from the MONITOR OUTs and your monitor TV are not matched, the
picture is not clear, natural or displayed. In this case, change the setting of the resolution on either this unit or the source
component (DVD player, etc.) to one which the monitor TV can handle. (For details, refer to "When selecting the Video
Scaling" on page 59 or the operating instructions of the source component.)
• When you want to enjoy only the picture on your TV, not the sound, you should set the HDMI Audio Output to Off not to output
the digital audio signal from the HDMI MONITOR OUT of this receiver. (For details, refer to "When selecting the HDMI Audio
Output" on page 60.)
■Component video input default settings: (*2)
• If you connect the COMPONENT VIDEO INs to your video components, it is easier to do so following the default settings.
• If your component video connections are different from the default setting, you should assign the COMPONENT VIDEO INs
you used with the "When selecting the Video Assign" procedure on page 70.
• The default settings are as follows:
COMPONENT IN 1 : VIDEO 1, COMPONENT IN 2 : VIDEO 2, COMPONENT IN 3 : VIDEO 3
• There are three types of video jacks (COMPONENT, S-VIDEO, (composite) VIDEO) for analog video connections and the
HDMI connectors for digital video and audio connections.
Connect them to the corresponding video jacks according to their capability.
• For your reference, the excellence in picture quality is as follows : "HDMI” > "COMPONENT" > "S-VIDEO" > "(composite)
VIDEO" .
• When making COMPONENT VIDEO connections, connect "Y" to "Y", "PB/CB" to "CB"(or "B-Y", "PB") and "PR/CR" to "CR"(or
"R-Y", "PR").
• When recording video program sources through VIDEO 1 OUT jacks or viewing ROOM 2 source through ROOM 2 OUT
jacks, you must use the same type of video jacks that you did connect to video playback components such as DVD player,
cable TV tuner, etc.
Continued
ENGLISH
• The video signals are output from the HDMI MONITOR
OUT only depending on the Video Mode setting.
Video conversion
• This unit is equipped with a function that up-converts the video signals to the higher quality video signals and down-converts
the video signals to the lower quality video signals and outputs them from the MONITOR OUTs.
• Depending on how to make video connections between this unit and video components, you should set the Monitor Output
and the Video Mode correctly to output the video signals from the connected MONITOR OUT(s). (For details, refer to "When
selecting the Monitor Output" on page 59 and "When selecting the Video Mode" on page 70.)
• Depending on each Monitor Output setting, the video signal flow is as follows :
■When Monitor Output is set to HDMI
R-972(A)_ENG_090225:R-972(A) 2009-04-15 오 9:00 페이지 7