Filter
Top Products
27
Operating a macro function
■Notes:
• The codes programmed into a MACRO button will be
transmitted at an interval of 0.5 seconds. However, some
components may not be able to complete one operation
in 0.5 seconds and may miss the next code.
In this case, the macro function cannot control the
corresponding components correctly.
• Be sure to use the remote control within the remote
control operation range of the components.
• Depending on the operation status of the components,
etc., the macro function cannot control the corresponding
components correctly.
• Aim the remote control at the REMOTE
SENSORs of the components to be controlled
and press the MACRO button you want.
Example : When pressing "M1" button.
1. Perform the steps 3 and 4 in "Entering a setup
code" procedure on page 22 to select a master
device and the punch-through mode ("PUNCH").
2. While "VOL" is displayed, press the CURSOR
UP(▲)/DOWN(▼) buttons to select the desired
punch-through mode, then press the ENTER
button.
Programming a punch-through function
• The punch-through function allows the volume controls,
channel controls or transport controls to link to a
different device while a device is controlled with this
remote control as a master device.
• For example, since this receiver will likely be used as
the sound system while watching TV, you may want to
use volume controls to operate this receiver although
this remote control is set to control the TV.
• Each time the CURSOR UP(
▲)/DOWN(▼) buttons
are pressed, the mode changes as follows:
→ VOL : The volume punch -through mode allows the
"VOLUME ▲/▼" and "MUTE" buttons to
operate a different device.
DELETE : All punch-through deleting mode.
PLAY : The transport punch-through mode allows the
"◀◀", "●", "▶▶", "
■
◀◀", "■", "▶▶
■
" , "◀/
■■
"
and "▶" buttons to operate a different device.
→ CH : The channel punch-through mode allows the
"CHANNEL ∧ /∨ " and "CH. LEVEL" buttons to
operate a different device.
• Then the device to which you can link the selected
punch-through mode is displayed.
• Then "VOL" is displayed on the LCD screen for several
seconds.
↕
↕
↕
ENGLISH
R-972(A)_ENG_090225:R-972(A) 2009-04-15 오 9:00 페이지 27