Filter
Top Products
ENGLISH
67
■Note :
• Depending on the speaker settings("No", etc.), some channels
cannot be selected.
• Only when the Trinnov Position is set to "None", you can set the Speaker Level Trim manually. (For details, refer to "When
selecting the Trinnov Position" on page 72.)
• The LFE level can be adjusted within the range of -10 ~ 0 dB
and other channel levels within the range of -15 ~ +15 dB
• In general, we recommend the LFE level to be adjusted to 0
dB.(However, the recommended LFE level for some early
DTS software is -10 dB.) If the recommended levels seem too
high, lower setting as necessary.
■When adjusting the LFE level
①. Press the CURSOR UP(▲)/DOWN(▼) buttons to select the LFE, then press the ENTER button.
②. Press the CURSOR UP(▲)/DOWN(▼) buttons to select the desired program source.
2. Press the CURSOR UP(▲)/DOWN(▼) buttons to select the desired channel.
4. Repeat the above steps 2 and 3 to adjust each channel level.
3. Press the CURSOR LEFT(◀)/RIGHT(▶) buttons to adjust the level of the selected channel or program
source's LFE as desired.
When selecting the Speaker Level Trim
1. Press the CURSOR UP(▲)/DOWN(▼) buttons to select the Speaker Level Trim, then press the ENTER
button.
Memory mode
levels either according to the program sources or to suit your tastes.(For details, refer to "Adjusting each channel level with
test tone" on page 40.)
■Adjusting the current channel level
• You can adjust the current channel levels as desired. These
adjusted levels are just memorized into user’s memory("TRIM"),
not into preset memory("REF 1", "REF 2").
• After adjusting each channel level with test tone, adjust the channel
R-972(A)_ENG_090225:R-972(A) 2009-04-15 오 9:01 페이지 67