Filter
Top Products
34
ENGLISH
QUICK SETUP
Assigning the HDMI INs
• "HDMI ~ " is displayed for several seconds.
• When "HDMI ~ " disappears, press the HDMI ASSIGN
button again.
• You can also make settings for input sources directly by
using some buttons on the front panel without
performing OSD menu setting procedures.
• You should assign the connected HDMI INs to the
desired of VIDEO 1 ~ VIDEO 5. (For details, refer to
"CONNECTING VIDEO COMPONENTS" on pages 6~8.)
1. Press the HDMI ASSIGN button.
• Each time the MULTI CONTROL knob is rotated or the
CURSOR LEFT(◀)/RIGHT(▶) buttons are pressed, the
corresponding HDMI IN is selected as follows :
→ HDMI 1 ↔ HDMI 2 ↔ HDMI 3 ←
→ - - - ↔ HDMI 4 ←
(No assignment)
■Note:
• In such a case that a HDMI IN is assigned two input
sources or more, when these input sources are
selected, the uncompressed digital video signals (and
digital audio signals when the HDMI Audio Output is set
to On) input into the same HDMI IN can be output from
the HDMI MONITOR OUT of this receiver.
2. Select the desired of HDMI 1 ~ HDMI 4, while
displaying "HDMI ~".
Setting the MONITOR OUTPUT
• You should select the MONITOR OUT which is
connected to your TV.
• Depending on the VIDEO MODE setting, this unit can
convert video signals and output them from the
MONITOR OUT to which the MONITOR OUTPUT is
set. (For details, refer to "Video conversion" on page 7.)
■Note:
• If no picture or no OSD menu will be displayed on your
TV, be sure to set the MONITOR OUTPUT and the
VIDEO MODE correctly.
1. Press the MONITOR OUTPUT button.
• "MONITOR ~ " is displayed for several seconds.
• When "MONITOR ~ " disappears, press the MONITOR
OUTPUT button again.
• Each time the MULTI CONTROL knob is rotated or the
CURSOR LEFT(◀)/RIGHT(▶) buttons are pressed, the
corresponding monitor output mode is selected as
follows :
→ HDMI : The video signals are output from the HDMI
MONITOR OUT only.
COMP(ONENT) : The video signals are output from
the COMPONENT MONITOR
OUTs only.
→SCVID(EO) : The video signals are output from the
(composite) VIDEO, the S-VIDEO and
the COMPONENT MONITOR OUTs.
↕
↕
2. Select the desired monitor output mode while
displaying "MONITOR ~ ".
R-972(A)_ENG_090225:R-972(A) 2009-04-15 오 9:00 페이지 34