Filter
Top Products
ENGLISH
10
• The OPTICAL and the COAXIAL DIGITAL OUTs of the
components that are connected to this unit can be connected
to these DIGITAL INs.
• A digital input should be connected to the components such
as a CD player, DVD player, etc. capable of outputting DTS
Digital Surround, Dolby Digital or PCM format digital signals,
etc.
• If the component with OPTICAL IN jack is connected to the
OPTICAL OUT jack of this unit, you can record the high
quality sound of CDs, etc. without degradation.
• For details, refer to the operating instructions of the
component connected.
• When making the COAXIAL DIGITAL connection, be sure to
use a 75 Ω COAXIAL cord, not a conventional AUDIO cord.
• Some of the commercially available optical fiber cords cannot
be used for the equipment. If there is an optical fiber cord
which cannot be connected to your equipment, consult your
dealer or nearest service organization.
■Notes :
• Be sure to make either a OPTICAL or a COAXIAL DIGITAL
connection on each component. (You don’t need to do both.)
• Depending on the digital audio signal format input into the
HDMI IN connector, some digital signals cannot be output
from the OPTICAL OUT jack.
■Digital input default settings
• If you connect the DIGITAL INs to your components, it is easier to do so following the default settings.
• If your DIGITAL connections are different from default settings, you should assign the DIGITAL INs you used with the
"When selecting the Audio Assign" procedure on page 70.
• The default settings are as follows :
OPTICAL IN 1:VIDEO 1, OPTICAL IN 2:VIDEO 2, OPTICAL IN 3:VIDEO 3, OPTICAL IN 4: VIDEO 4
(Front) OPTICAL IN 5: VIDEO 5, COAXIAL IN 1 : CD
• Use these jacks when adding additional power amplifiers.
• Connect the PRE OUT jacks to the powered speakers or the power amplifiers connected to speakers respectively.
• When using only one surround back speaker, connect the SURROUND BACK LEFT jack to the power amplifier.
• To emphasize the deep bass sounds, connect a powered subwoofer.
■Notes :
• After installing the speakers, first adjust the speaker settings according to your environment and speaker layout (For details,
"SETTING THE SPEAKER/LISTENING SETUP" on page 61.)
• According to speaker settings, some channels of PRE OUTs cannot output audio signals.
5. CONNECTING DIGITAL INS AND OUT
6. CONNECTING PRE OUTS
R-972(A)_ENG_090225:R-972(A) 2009-04-15 오 9:00 페이지 10