Sherwood R-972 Stereo Receiver User Manual


 
ENGLISH
32
LISTENING TO A PROGRAM SOURCE
Operations
Before operation
• Enter the standby mode.
• The POWER ON/STANDBY button lights up
amber. This means that the receiver is not
disconnected from the AC mains and a small
amount of current is retained to support the
operation readiness.
• To switch the power off, push the POWER
switch again.
Then the power is cut off and the
POWER ON/STANDBY button goes off.
• Then the SPEAKER indicator ( ) lights
up and the sound can be heard from the
speakers connected to the speaker
terminals.
• When using the headphones for private
listening, press the SPEAKER button again
to switch the speakers off.
• Each time the "AUDIO" button on the front panel is
pressed, the input source changes as follows:
→CD →TAPE →USB
• Each time the "VIDEO" button on the front panel is
pressed, the input source changes as follows:
→VIDEO 1 →VIDEO 2 → - - - →VIDEO 5
• Each time the "TUNER" button is pressed, the band
changes as follows:
→FM STEREO →FM MONO →AM →XM
When selecting the EXTERNAL IN as desired,
• Depending on the power amplifier setting for the
surround back channels and the surround back speaker
setting, "EXT. IN" is displayed and 8(/7/6) separate
analog signals from the component connected to this
input pass through the volume circuits only and can be
heard from your speakers.
• Select the desired input source to cancel the external in
function.
• These analog signals can be heard only, not recorded.
Notes:
• Before operating this receiver with the supplied remote control, refer to "Universal Remote Controls" on page 19 for details
about operation.
• Before operating this receiver, first set this unit as desired for optimum performance, doing the OSD menu setting
procedures. (For details, refer to "OSD Menu Settings" on page 56.)
• Each time the POWER ON/STANDBY button on the front
panel is pressed, the receiver is turned on to enter the
operating mode (the POWER ON/ STANDBY button
lights up blue) or off to enter the standby mode(the
POWER ON/STANDBY button lights up amber).
• On the remote control, press the POWER ON button to
enter the operating mode or press the STANDBY button
to enter the standby mode.
1. In the standby mode, turn the power on.
3. Select the desired input source.
2. Switch the speakers on.
R-972(A)_ENG_090225:R-972(A) 2009-04-15 오 9:00 페이지 32