Filter
Top Products
ENGLISH
36
Continued
• Each time the MULTI CONTROL knob is rotated or the
CURSOR LEFT(◀)/RIGHT(▶) buttons are pressed, the
corresponding audio input mode is selected as follows :
→ AUTO : When there are multiple audio input signals,
the audio input signals are detected and the
audio input signal to be played is selected
automatically in the priority of them :
HDMI audio>DIGITAL audio>ANALOG audio
HDMI : The signal that is input into the HDMI IN is
always played.
DGTL : The signal that is input into the OPTICAL or
(DIGITAL) the COAXIAL DIGITAL IN is always played.
→ANLG : The signal that is input into the analog
(
ANALOG)
AUDIO INs is always played.
↕
↕
↕
• You should assign the connected DIGITAL INs to the
desired of CD and VIDEO 1 ~ VIDEO 5.
• If the AUDIO MODE is set to the mode other than
"DIGITAL", you cannot hear the sound from the
selected digital input. (For details, refer to "Setting the
AUDIO MODE" on this page.)
1. Press the AUDIO ASSIGN button.
2. Select the desired of the digital inputs connected
while displaying "AUDIO ~ ".
• "AUDIO ~ " is displayed for several seconds.
• When "AUDIO ~ " disappears, press the AUDIO ASSIGN
button again.
Assigning the DIGITAL INs
• Each time the MULTI CONTROL knob is rotated or the
CURSOR LEFT(◀)/RIGHT(▶) buttons are pressed,
the corresponding input is selected as follows :
→ OPT(ical) 1 → ~ → OPT(ical) 5 ←
- - - ←COAX(ial) 2 ←COAX(ial) 1 ←
(No assignment)
■Notes:
• When the selected digital input is not connected, the
"DIG." indicator flickers and no sound will be heard.
• In such a case that a DIGITAL IN is assigned to two
input sources or more, when these input sources are
selected, the digital audio signals can be heard from the
same DIGITAL IN.
R-972(A)_ENG_090225:R-972(A) 2009-04-15 오 9:00 페이지 36