Filter
Top Products
95
STEPS TO ERASE SOURCE-COMPONENT POWER
To erase source-component power commands, follow the same steps as if you were going to store the power
command up to when you would press the remote to enter the command. Press PROGRAM to exit. The power
command is erased automatically.
Step 1
- Press and hold the PROGRAM key to enter Program Mode. The POWER/(MASTER KEY SEQ) LED
turns on RED, and the PAGE LED blinks RED.
Step 2
- Press the Master Key where you wish to erase source IR commands. The PAGE LED turns off, and
the ENTER IR LED turns on GREEN.
Step 3
- Press PROGRAM to back out and erase another source power command. The POWER/(MASTER KEY
SEQ) LED turns on RED, and the PAGE LED blinks RED. Repeat from step 2 to erase the other power command.
or
Press PROGRAM twice to exit
STEPS TO ERASE FUNCTION-KEY IR PROGRAMMING
To erase individual IR commands in any of the pages, follow the same steps as if you were going to store the
command up to when you would press the key to be programmed. Once pressed, any command stored for
that key is erased.
Step 1
- Press and hold the PROGRAM key to enter Program Mode. The POWER/(MASTER KEY SEQ) LED
turns on RED, and the PAGE LED blinks RED. Then press the NEXT button twice. The FUNCTION KEY
IR/(SEQ.) LED turns on RED, and the PAGE LED blinks, RED.
Step 2
- Press the appropriate Master Key, tap the OFF Key, or press and hold the OFF key on the Master
Keypad to identify the page where the command is stored. (For more information see Master-Key Pages.)
The PAGE LED turns off, and the KEY LED blinks RED.
Step 3
- Press the Function Key where the command is stored.
The KEY LED turns off, and the ENTER IR LED turns on RED.
Step 4
- Press the PROGRAM button. The IR command is automatically erased.
The ENTER IR LED turns off. The KEY LED blinks RED.
You can continue deleting commands from that page.
Repeat steps 3 and 4 until all IR commands have been erased.
or
With the KEY LED blinking RED, press the PROGRAM button.
The KEY LED turns off, and the Page LED blinks RED.
Step 5
- You can continue erasing IR commands from other pages. Repeat steps 2 through 4 until all the
necessary IR commands have been erased.
Step 6
- Press PROGRAM twice to exit.
PROGRAM-EDITING STEPS