Filter
Top Products
PROGRAMMING PANEL
IR commands needed for control of connected external source components are programmed into the A4.6Ci’s
program memory using the hidden programming controls on the front panel (see Figure 42).
Programming is accomplished by using the hidden panel’s push buttons and LED prompts, and by sending
commands from connected Niles Master Keypad and Accessory Keypad Modules, and IR commands from the
remotes supplied with the source components (see Figure 41). A Niles hand-held R-4 Remote can be used
instead of a connected Master Keypad Module (see Figure 42). For complete information on the A4.6Ci’s step-
by-step programming procedure, refer to the Programming Steps section of this manual.
45
PROGRAMMING OVERVIEW
Figure 42
Niles hand-held
R-4 Remote Control
(sold separately)
Source Components
IR Remote Control
(supplied by manufacturer)
Hidden Installer
Programming Panel
Figure 41
Source Components
IR Remote Control
(sold separately)
Hidden Installer
Programming
Panel
Select™
or Solo™
Transport™ Numeric™
Note: R-4 does not include Master Keys 5-8.