Filter
Top Products
90
EDIT MASTER KEY SEQUENCE PROGRAMMING
Step 1
- Press and hold the PROGRAM button.
Step 2
- Press the NEXT button three times.
The (POWER)/MASTER KEY SEQ LED turns on GREEN, the TRIGGER LED turns on RED, and the PAGE LED
blinks RED
Step 3
- Press the Master Key to edit.
The TRIGGER LED turns off, and the PAGE LED continues to blink RED.
Step 4
- Press the Master Key that identifies the Master Key Page where the IR command is stored for the
first step in the Master Key Sequence you are editing.
or
Tap the OFF Key if the IR command is in the Default Page.
or
Press and hold the OFF key if the IR command is in the Library Page.
The PAGE LED turns off, and the KEY LED blinks RED.
Step 5
- Press the function key where the IR command is stored.
The KEY LED turns off, and the PAGE LED blinks RED.
Step 6
- You can now identify the Master-Key Page where the IR command is stored for the second step in
the Master Key Sequence you are editing.
Note: If the sequence includes a DELAY:
i. Press the DELAY button (instead of a function key) while the PAGE LED is blinking RED. The PAGE LED
turns off, and the KEY LED blinks RED.
The first four keys on the Master-Key Module illuminate.
ii. Choose the Master Key for the desired delay time. Refer to the table below:
After you choose a delay, all Master Keys turn off. The KEY LED turns OFF, and the PAGE LED blinks RED.
PROGRAM-EDITING STEPS
DELAY TABLE
KEY
Master Key 1
DELAY TIME
.5 seconds
Master Key 2 1 seconds
Master Key 3 4 seconds
Master Key 4 8 seconds