TERMINATING FOUR-PAIR TWISTED CABLE
The Solo
™
and Select
™
Master Keypad Modules, the expander, and the A4.6Ci’s system-expansion connections
require a four-pair twisted cable with a one-to-one wiring configuration. To maintain consistency throughout
all Intellipad
®
Ci installations, we recommend the color-coding pattern described in Figure 31. However, you
may follow the color-coding pattern of your choice, as long as it is consistent throughout the system.
39
CONNECTIONS
1234
Pair 2
Pair 1
T568A
Pair 3 Pair 4
567
8
1 = Green/White
2 = Green
3 = Orange/White
4 = Blue
5 = Blue/White
6 = Orange
7 = Brown/White
8 = Brown
Figure 31
Solo
™
Master
Keypad Module
Numeric
™
Accessory
Keypad Module
RJ-45 Connector for
connection to Master
Keypad Module
RJ-45 Connector
for connection to
Numeric
™
Accessory
Keypad Module
RJ-45 Connector
for connection to
IR Sensors
RJ-45 Connector for
connection to
the ZR-4630
Included
Jumper Cable
IR SENSOR
INPUT
OUTPUT
SYSTEM
ACCESSORY
KEYPADS
Figure 32
Figure 33
CONNECTING
NUMERIC
™
KEYPADS
Each Solo
™
and Select
™
Master Keypad
Module can be mated with one
optional Numeric
™
Accessory Keypad
Module using an included jumper
cable (see Figure 33).
CONNECTING THE SOLO
™
AND SELECT
™
MASTER KEYPADS TO
THE HOME RUN OF FOUR-PAIR TWISTED CABLE
The home run of four-pair twisted cable is terminated with a male
RJ-45 connector and plugged into the rear-panel jack labeled SYS-
TEM on the Solo
™
and Select
™
Master Keypad Module (see Figure 32).