Filter
Top Products
80
Can I program a button to execute more than one
command?
No, you can not. However, you can create a macro to execute a
sequence of commands (see page 73, 75).
How do I program source switching?
See “Programming device items” on page 71.
How can I edit, label or delete buttons on home panels?
You can do this via the Device menu items. All changes you make to
these items are automatically updated in the Home menu.
How do I reset the Remote controller?
Normally, you never have to reset the Remote controller. However,
if the Remote controller’s display freezes or if you notice unusual
behavior, you might need to reset. You will not lose any saved
programmed commands or macros.
• Carefully press the reset button on the back of the Remote
controller with a paperclip or sharp pencil. The remote controller
restarts and beeps to indicate it is ready for use.
How do I revert to the original configuration?
Reverting to the original configuration restores the remote
controller’s devices and commands to its state when you purchased
it. This means that all programming is lost permanently. Normally,
you never have to revert the Remote controller.
1. Touch and hold the Remote controller icon for a few
seconds.
The first setup panel appears.
2. Scroll to the second setup panel.
3. Tap the Revert button.
4. Tap Revert to confirm the action.
How do I calibrate the touchscreen?
The remote controller is calibrated when it leaves the factory, so
normally you do not have to calibrate it yourself. It is possible that
the remote controller displays a message to calibrate the
touchscreen. If this message appears, do the following:
1. Tap as close as possible to the arrow tip on the
upper left corner of the screen.
2. Tap as close as possible to the arrow tip on the
bottom right corner of the screen.
FAQ