Filter
Top Products
15
Second operation menu (page 2/4)
Listening mode buttons [35]
You can select a listening mode.
Display button [33]
For changing the display in the front display.
Re-EQ button [57, 60]
Depending on the listening mode, you can turn the Re-EQ function
on or off.
Third operation menu (page 3/4)
Setup button [43]
Press to display the Setup Menu on the TV screen and in the display.
Press again to exit the menu.
Return button [43]
Press to enter the selected setting and return to the previous menu.
Test button [48]
This button is used to set the speaker output levels. Use this button in
conjunction with the LEVEL
/ and CH SEL buttons to calibrate
the speakers levels without entering the Setup Menu.
Dim button [34]
Adjusts the display brightness.
There are three settings available: normal, dark and very dark.
/ / / , Enter buttons [43]
When in the Setup Menu, press the upper and lower arrow buttons to
select an item, press the right and left arrow buttons to select parameter
values or modes, and press the Enter button to advance to the next item.
Sleep button [34]
Press to set the sleep function.
The SLEEP button enables you to set the DTR-8.3 to turn off
automatically after a specified time period.
+/– buttons [34, 48]
Select the speaker whose volume is to be adjusted using the CH Sel
button and adjust the volume using the +/– buttons.
SP A/B buttons
These buttons are not used with the DTR-8.3.
CH Sel button [34]
Press to select a speaker channel when adjusting the speaker level.
FM/AM buttons [36]
Select the tuner band.
Not used with the DTR-8.3.
The buttons can be used to do direct tuning or tune in a radio station
on some Onkyo products.
Index parts and facilities
For details on how to use the remote controller, refer to “Using
the remote controller” (page 64).
Select AV Amp in the Home menu to display the operation buttons.
CONT +/– buttons
If the display stays blank or becomes black, adjust the contrast dial
on the left side.
LIGHT button
Press to turn on the backlight for brighter display when you use the
DTR-8.3 in the dark room.
The backlight shuts off automatically after a few seconds to save
power.
Note:
You can choose to activate the backlight automatically when you
activate the remote controller. (For details about the settings, see
“Second setup panel” under “Adjust the Settings” on page 64.)
AV amp button
Before operating the DTR-8.3, press this button.
ZONE 2 button [41]
Press to perform operations on the remote zone.
Net A button
Press to listen to the Net Audio.
MUTE button [33]
Press to activate the mute function.
CH +/– button [37, 41]
When AV Amp is selected, for selecting a tuner preset channel.
VOL / buttons [31, 35, 41]
When AV Amp is selected, for adjusting the volume. When Zone 2
is selected, for adjusting the volume in the Zone 2.
First operation menu (page 1/4)
ON button [30, 41]
Press to turn on the DTR-8.3.
OFF button [30]
Press to place the DTR-8.3 in the standby state.
Be aware that pressing the STANDBY button only places the DTR-
8.3 in standby and does not turn the power completely off.
LISTEN button [32]
For displaying the 2/4 listening mode page.
SETUP button
For displaying the 3/4 setup operation page.
Input Selector buttons [31, 36, 41]
Select an input source for the main zone.
Audio Sel button [35]
Press to select the audio input signal.