Filter
Top Products
70
You can program the remote controller commands by transmitting
infrared signals from your existing remote controls to the remote
controller’s learning eye. To do this, place the remote controller and
the device’s remote controller on a flat surface, 6 to 8 inches(15 to 20
cm ) apart.
The following buttons can be programmed: control panel buttons,
Device menu items, direct-access buttons and Left/Right buttons.
You cannot program Home menu buttons directly. You need to
program them by following the Device menu.
The remote controller also offers empty control panel buttons you
can program and labelL as existing buttons. They are only visible in
LEARN and LABEL mode and appear without label or with label
(intended for a specific function). You will also see previously
deleted buttons: you can restore them by reprogramming them or
you can reuse them for other commands.
Programming Buttons
6 to 8 inches
(15 to 20 cm )
Programming control panel buttons
1. Navigate to the control panel buttons you want to
program.
2. Switch to LEARN mode by using the Mode button.
Additional empty buttons appear: they can be programmed and
labeled as existing buttons.
3. Point the device’s original remote controller to the
remote controller’s learning eye as shown on this
page.
4. Tap the remote controller button you want to
program.
The button starts blinking.
5. Press and hold the corresponding button on your
device’s original remote controller.
If the remote controller has learned the command successfully,
OK blinks on the remote controller icon. You can let go of the
button you’re holding.
If the remote controller has not learned the command
successfully, you hear a short buzz and FAIL appears on the
remote controller icon.
6. Program all other buttons you want and relabel them
as necessary (see page 72).
7. Return to Use mode by using the Mode button.